Volt: Difference between revisions
m Aligned the picture of Herman Helmholtz with his friends to the right instead to the left such that the sections 'See Also' and 'References' do not get misaligned in the vertical axis. |
Tag: references removed |
||
| Line 26: | Line 26: | ||
\text{V} = \text{A} {\cdot} \Omega = \frac{\text{W}}{\text{A}} = \frac{\text{J}}{\text{C}} = \frac{\text{eV}}{e}.</math> |
\text{V} = \text{A} {\cdot} \Omega = \frac{\text{W}}{\text{A}} = \frac{\text{J}}{\text{C}} = \frac{\text{eV}}{e}.</math> |
||
ako ay pogi or i am handsome |
|||
=== Josephson junction definition === |
|||
{{main|Josephson voltage standard}} |
|||
The "[[Conventional electrical unit|conventional]]" volt, V<sub>90</sub>, defined in 1988 by the 18th [[General Conference on Weights and Measures]] and in use from 1990, is implemented using the [[Josephson effect]] for exact frequency-to-voltage conversion, combined with the [[Caesium standard|caesium frequency standard]]. For the [[Josephson constant]], ''K''<sub>J</sub> = 2''e''/''h'' (where ''e'' is the [[elementary charge]] and ''h'' is the [[Planck constant]]), the "conventional" value ''K''<sub>J-90</sub> is used: |
|||
:<math alt="K J-90 equals 0.4835979 gigahertz per microvolt"> |
|||
K_\text{J-90} = 0.4835979\,\frac{\text{GHz}}{\mu\text{V}}.</math> |
|||
This standard is typically realized using a series-connected array of several thousand or tens of thousands of [[Junction (semiconductor)|junctions]], excited by microwave signals between 10 and 80 GHz (depending on the array design).<ref name=ieee-josephson>{{Citation |url=http://ieeexplore.ieee.org/xpl/articleDetails.jsp?reload=true&arnumber=783938 |title=1 Volt DC Programmable Josephson Voltage Standard |first1=Charles J. |last1=Burroughs |first2=Samuel P. |last2=Bent |first3=Todd E. |last3=Harvey |first4=Clark A. |last4=Hamilton |journal=IEEE Transactions on Applied Superconductivity |date=1999-06-01 |volume=9 |number=3 |pages=4145–4149 |issn=1051-8223 |publisher=[[Institute of Electrical and Electronics Engineers]] (IEEE) |doi=10.1109/77.783938 |accessdate=2014-06-27|bibcode=1999ITAS....9.4145B }}</ref> Empirically, several experiments have shown that the method is independent of device design, material, measurement setup, etc., and no correction terms are required in a practical implementation.<ref>{{Citation |title=Current status of the quantum metrology triangle |first=Mark W |last=Keller |url=http://qdev.boulder.nist.gov/817.03/pubs/downloads/set/Metrologia%2045,%20102.pdf |journal=Metrologia |volume=45 |number=1 |pages=102–109 |date=2008-01-18 |issn=0026-1394 |doi=10.1088/0026-1394/45/1/014 |quote=Theoretically, there are no current predictions for any correction terms. Empirically, several experiments have shown that ''K''<sub>J</sub> and ''R''<sub>K</sub> are independent of device design, material, measurement setup, etc. This demonstration of universality is consistent with the exactness of the relations, but does not prove it outright. |bibcode=2008Metro..45..102K |access-date=2010-04-11 |archive-url=https://web.archive.org/web/20100527094953/http://qdev.boulder.nist.gov/817.03/pubs/downloads/set/Metrologia%2045,%20102.pdf |archive-date=2010-05-27 |dead-url=yes |df= }}</ref> |
|||
== Water-flow analogy == |
== Water-flow analogy == |
||
Revision as of 12:18, 19 February 2019
| Volt | |
|---|---|
 Josephson voltage standard chip developed by the National Bureau of Standards as a standard volt | |
| General information | |
| Unit system | SI derived unit |
| Unit of | Electric potential, electromotive force |
| Symbol | V |
| Named after | Alessandro Volta |
| In SI base units: | kg·m2·s−3·A−1 |
The volt (symbol: V) is the derived unit for electric potential, electric potential difference (voltage), and electromotive force.[1] It is named after the Italian physicist Alessandro Volta (1745–1827).
Definition
One volt is defined as the difference in electric potential between two points of a conducting wire when an electric current of one ampere dissipates one watt of power between those points.[2] It is also equal to the potential difference between two parallel, infinite planes spaced 1 meter apart that create an electric field of 1 newton per coulomb. Additionally, it is the potential difference between two points that will impart one joule of energy per coulomb of charge that passes through it. It can be expressed in terms of SI base units (m, kg, s, and A) as
It can also be expressed as amperes times ohms (current times resistance, Ohm's law), watts per ampere (power per unit current, definition of electric power), or joules per coulomb (energy per unit charge), which is also equivalent to electronvolts per elementary charge:
ako ay pogi or i am handsome
Water-flow analogy
In the water-flow analogy, sometimes used to explain electric circuits by comparing them with water-filled pipes, voltage (difference in electric potential) is likened to difference in water pressure. Current is proportional to the diameter of the pipe or the amount of water flowing at that pressure. A resistor would be a reduced diameter somewhere in the piping and a capacitor/inductor could be likened to a "U" shaped pipe where a higher water level on one side could store energy temporarily.
The relationship between voltage and current is defined (in ohmic devices like resistors) by Ohm's law. Ohm's Law is analogous to the Hagen–Poiseuille equation, as both are linear models relating flux and potential in their respective systems.
Common voltages
The voltage produced by each electrochemical cell in a battery is determined by the chemistry of that cell. See Galvanic cell § Cell voltage. Cells can be combined in series for multiples of that voltage, or additional circuitry added to adjust the voltage to a different level. Mechanical generators can usually be constructed to any voltage in a range of feasibility.
Nominal voltages of familiar sources:
- Nerve cell resting potential: ~75 mV[3]
- Single-cell, rechargeable NiMH[4] or NiCd battery: 1.2 V
- Single-cell, non-rechargeable (e.g., AAA, AA, C and D cells): alkaline battery: 1.5 V;[5] zinc-carbon battery: 1.56 V if fresh and unused
- LiFePO4 rechargeable battery: 3.3 V
- Cobalt-based Lithium polymer rechargeable battery: 3.75 V (see Comparison of commercial battery types)
- Transistor-transistor logic/CMOS (TTL) power supply: 5 V
- USB: 5 V DC
- PP3 battery: 9 V
- Automobile battery systems are 2.1 volts per cell; a "12V" battery is 6 cells or 12.6V; a "24V" battery is 12 cells or 25.2V. Some antique vehicles use "6V" 3-cell batteries or 6.3 volts.
- Electric vehicle battery: 400 V when fully charged[6]
- Household mains electricity AC: (see List of countries with mains power plugs, voltages and frequencies)
- 100 V in Japan
- 120 V in North America,
- 230 V in Europe, Asia, Africa and Australia
- Rapid transit third rail: 600–750 V (see List of railway electrification systems)
- High-speed train overhead power lines: 25 kV at 50 Hz, but see the List of railway electrification systems and 25 kV at 60 Hz for exceptions.
- High-voltage electric power transmission lines: 110 kV and up (1.15 MV was the record as of 2005[citation needed])
- Lightning: Varies greatly, often around 100 MV.
History
 | This section needs additional citations for verification. (June 2014) |
In 1800, as the result of a professional disagreement over the galvanic response advocated by Luigi Galvani, Alessandro Volta developed the so-called voltaic pile, a forerunner of the battery, which produced a steady electric current. Volta had determined that the most effective pair of dissimilar metals to produce electricity was zinc and silver. In 1861, Latimer Clark and Sir Charles Bright coined the name "volt" for the unit of resistance.[7] By 1873, the British Association for the Advancement of Science had defined the volt, ohm, and farad.[8] In 1881, the International Electrical Congress, now the International Electrotechnical Commission (IEC), approved the volt as the unit for electromotive force.[9] They made the volt equal to 108 cgs units of voltage, the cgs system at the time being the customary system of units in science. They chose such a ratio because the cgs unit of voltage is inconveniently small and one volt in this definition is approximately the emf of a Daniell cell, the standard source of voltage in the telegraph systems of the day.[10] At that time, the volt was defined as the potential difference [i.e., what is nowadays called the "voltage (difference)"] across a conductor when a current of one ampere dissipates one watt of power.
The "international volt" was defined in 1893 as 1/1.434 of the emf of a Clark cell. This definition was abandoned in 1908 in favor of a definition based on the international ohm and international ampere until the entire set of "reproducible units" was abandoned in 1948.
Prior to the development of the Josephson junction voltage standard, the volt was maintained in national laboratories using specially constructed batteries called "standard cells". The United States used a design called the Weston cell from 1905 to 1972.
A proposed redefinition of SI base units, including defining the value of the elementary charge, is expected to take effect in 2019.[11]
See also
References
- ^ "SI Brochure, Table 3 (Section 2.2.2)". BIPM. 2006. Archived from the original on 2007-06-18. Retrieved 2007-07-29.
{{cite web}}: Unknown parameter|deadurl=ignored (|url-status=suggested) (help) - ^ BIPM SI Brochure: Appendix 1, p. 144
- ^ Bullock, Orkand, and Grinnell, pp. 150–151; Junge, pp. 89–90; Schmidt-Nielsen, p. 484
- ^ Hill, Paul Horowitz; Winfield; Winfield, Hill (2015). The Art of Electronics (3. ed.). Cambridge [u.a.]: Cambridge Univ. Press. p. 689. ISBN 978-0-521-809269.
{{cite book}}: CS1 maint: multiple names: authors list (link) - ^ SK Loo and Keith Keller (Aug 2004). "Single-cell Battery Discharge Characteristics Using the TPS61070 Boost Converter" (PDF). Texas Instruments.
- ^ 2012-2013 Model S Emergency Response Guide (PDF), retrieved 2017-08-06
- ^ As names for units of various electrical quantities, Bright and Clark suggested "ohma" for voltage, "farad" for charge, "galvat" for current, and "volt" for resistance. See:
- Latimer Clark and Sir Charles Bright (1861) "On the formation of standards of electrical quantity and resistance," Report of the Thirty-first Meeting of the British Association for the Advancement of Science (Manchester, England: September 1861), section: Mathematics and Physics, pp. 37-38.
- Latimer Clark and Sir Charles Bright (November 9, 1861) "Measurement of electrical quantities and resistance," The Electrician, 1 (1) : 3–4.
- ^ Sir W. Thomson, et al. (1873) "First report of the Committee for the Selection and Nomenclature of Dynamical and Electrical Units," Report of the 43rd Meeting of the British Association for the Advancement of Science (Bradford, September 1873), pp. 222-225. From p. 223: "The "ohm," as represented by the original standard coil, is approximately 109 C.G.S. units of resistance ; the "volt" is approximately 108 C.G.S. units of electromotive force ; and the "farad" is approximately 1/109 of the C.G.S. unit of capacity."
- ^ (Anon.) (September 24, 1881) "The Electrical Congress," The Electrician, 7 : 297.
- ^ Hamer, Walter J. (January 15, 1965). Standard Cells: Their Construction, Maintenance, and Characteristics (PDF). National Bureau of Standards Monograph #84. US National Bureau of Standards.
- ^ Draft Resolution A "On the revision of the International System of units (SI)" to be submitted to the CGPM at its 26th meeting (2018) (PDF)
External links
