my ef turbo ride

by **efboosted** » February 19th, 2009, 9:31 pm

Hi people this is my falcon. Its been my project car for about a year so far and getting down to the last bits of completion. Can't wait till it's done. Before taken it off the road i installed a cam and chip package from chip torque. It produced 220 hp with there basic tune.

by **BBQBurner** » February 19th, 2009, 11:31 pm

very nice

by **Malakai** » February 20th, 2009, 12:10 am

Not bad... what are the details on the parts in it?

by **efboosted** » February 20th, 2009, 7:09 am

pwr radiator and header tank.pwr intercooler. Ba xr6t fuel rail, injectors and reg. Crow cam P'N 2222549. The turbo is made up from bits and pieces. I think the rear housing is off a diesel perkins truck and the core i think is off a vl commodore. A.R is front housin .50 and the rear 1.00. It cost $200 bucks for it. Fully balance and a spare rebuild kit. A friend work at a mtq.3'' mandrel bent exhaust. custom turbo manifold. External tiel wastegate. I'll get some more pics up soon. I have the front bar on and fitted a catch can.

by **Eb Barbie** » February 20th, 2009, 7:17 am

Wow top stuff!! I like

by **EFFalcon** » February 20th, 2009, 8:30 am

Looks like a tidy install.
some new leads would neaten it up a little more.
good stuff

by **DOHC-EB** » February 20th, 2009, 8:49 am

Nice setup!!! out of curiosity what brake kit do you have??

by **efboosted** » February 21st, 2009, 12:58 pm

It's a UPC brake upgrade with 28mm wide hubs, rotors are 330mm, twin piston mustang calipers, steel braided brake lines, normal master cylinder. Can Fit 18x8 rims on it with room to spare. She pulls up on a 20c piece. One problem which needs to be rectified soon is, just before stopping the ABS is kicking in. I think its the clearence between the sensor and the tone wheel causing the problem.

by **DOHC-EB** » February 21st, 2009, 1:00 pm

efboosted wrote:It's a UPC brake upgrade with 28mm wide hubs, rotors are 330mm, twin piston mustang calipers, steel braided brake lines, normal master cylinder. Can Fit 18x8 rims on it with room to spare. She pulls up on a 20c piece. One problem which needs to be rectified soon is, just before stopping the ABS is kicking in. I think its the clearence between the sensor and the tone wheel causing the problem.

Yeah they are the same brakes as mine... I thought they were. Despitie what everyone says about thw UPC kit i think its a good bit of gear

by **efboosted** » February 22nd, 2009, 9:56 am

have you had any issues with the abs module operating just before stoping?

my ef turbo ride

my ef turbo ride

Re: my ef turbo ride

Re: my ef turbo ride

Re: my ef turbo ride

Re: my ef turbo ride

Re: my ef turbo ride

Re: my ef turbo ride

Re: my ef turbo ride

Re: my ef turbo ride

Re: my ef turbo ride

Who is online