Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Engine wiring harness / Installation

1. Set the engine wiring harness to the engine, and connect the connector.

NOTE:

• If the clip is damaged, replace it with a new part.

• Before replacing the clip, put an alignment mark (a) on both engine wiring harness and clip to remove the clip, and then align to the alignment mark (a) to attach a new clip to the engine wiring harness.

• Structural diagram 1

(1)	Engine harness connector (65P)
(2)	Tumble generator valve actuator RH
(3)	Throttle position sensor connector
(4)	Manifold absolute pressure sensor connector
(5)	Engine ground (2 locations)
(6)	Crankshaft position sensor
(7)	Knock sensor
(8)	Purge control solenoid valve connector
(9)	Engine coolant temperature sensor
(10)	Tumble generator valve actuator LH
(11)	Fuel injector (#4)
(12)	Engine harness connector (12P)
(13)	Fuel injector (#2)
(14)	Camshaft position sensor LH
(15)	Secure the clip to the screw hole.
(16)	Camshaft position sensor RH
(17)	Fuel injector (#1)
(18)	EGR valve
(19)	Fuel injector (#3)
(20)	Oil pressure switch
(21)	Engine oil temperature sensor
(22)	Intake oil control solenoid LH
(23)	Secure the clip to the main fuse box.
(24)	Secure the clip to the screw hole.
(25)	Oil level switch
(26)	Secure the clip to the oval hole.
(27)	Secure the clip to the screw hole.
(28)	Intake oil control solenoid RH
(29)	Maximum of 0 — 2 mm (0 — 0.079 in) gap is allowed.
(30)	Secure the clip to the screw hole.

Tightening torque: N·m (kgf-m, ft-lb)
T:	19 (1.9, 14.0)

• Structural diagram 2

(1)	Secure the clip to the screw hole.
(2)	Ignition coil No. 4
(3)	Ignition coil No. 2
(4)	Secure the clip to the screw hole.
(5)	Ignition coil No. 3
(6)	Ignition coil No. 1
(7)	Rear oxygen sensor
(8)	Front oxygen (A/F) sensor

2. Install the intake manifold assembly. Intake Manifold Assembly > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

Inspection

Check that the engine wiring harness does not have deformation, cracks and any other damage. ...

Front oxygen (a f) sensor

...

Other materials:

Dtc u0101 lost communication with tcm
DTC DETECTING CONDITION:No data is received from TCM.TROUBLE SYMPTOM:Cooperation control with transmission is not performed.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnostic Procedure with Diagnostic Trouble Code (DTC ...