Pentane is an organic compound with the formula C₅H₁₂—that is, an alkane with five carbon atoms. The term may refer to any of three structural isomers, or to a mixture of them: in the IUPAC nomenclature, however, pentane means exclusively the n-pentane isomer, in which case pentanes refers to a mixture of them; the other two are called isopentane (methylbutane) and neopentane (dimethylpropane). Cyclopentane is not an isomer of pentane because it has only 10 hydrogen atoms where pentane has 12.

Quick Facts Names, Identifiers ...

Pentane

Names
Preferred IUPAC name Pentane[1]
Other names Quintane;[2] Refrigerant-4-13-0
Identifiers
CAS Number	109-66-0 Y
3D model (JSmol)	Interactive image
Beilstein Reference	969132
ChEBI	CHEBI:37830 Y
ChEMBL	ChEMBL16102 Y
ChemSpider	7712 Y
DrugBank	DB03119 Y
ECHA InfoCard	100.003.358
EC Number	203-692-4
Gmelin Reference	1766
MeSH	pentane
PubChem CID	8003
RTECS number	RZ9450000
UNII	4FEX897A91 Y
UN number	1265
CompTox Dashboard (EPA)	DTXSID2025846
InChI InChI=1S/C5H12/c1-3-5-4-2/h3-5H2,1-2H3 Y Key: OFBQJSOFQDEBGM-UHFFFAOYSA-N Y
SMILES CCCCC
Properties[3]
Chemical formula	C5H12
Molar mass	72.151 g·mol−1
Appearance	Colourless liquid
Odor	Gasoline-like[4]
Density	0.626 g/mL; 0.6262 g/mL (20 °C)
Melting point	−130.5 to −129.1 °C; −202.8 to −200.3 °F; 142.7 to 144.1 K
Boiling point	35.9 to 36.3 °C; 96.5 to 97.3 °F; 309.0 to 309.4 K
Solubility in water	40 mg/L (20 °C)
log P	3.255
Vapor pressure	57.90 kPa (20.0 °C)
Henry's law constant (kH)	7.8 nmol Pa−1 kg−1
Acidity (pKa)	~45
Basicity (pKb)	~59
UV-vis (λmax)	200 nm
Magnetic susceptibility (χ)	-63.05·10−6 cm3/mol
Refractive index (nD)	1.358
Viscosity	0.240 mPa·s (at 20 °C)
Thermochemistry
Heat capacity (C)	167.19 J K−1 mol−1
Std molar entropy (S⦵298)	263.47 J K−1 mol−1
Std enthalpy of formation (ΔfH⦵298)	−174.1–−172.9 kJ mol−1
Std enthalpy of combustion (ΔcH⦵298)	−3.5095–−3.5085 MJ mol−1
Hazards
GHS labelling:
Pictograms
Signal word	Danger
Hazard statements	H225, H304, H336, H411
Precautionary statements	P210, P261, P273, P301+P310, P331
NFPA 704 (fire diamond)	1 4 0
Flash point	−49.0 °C (−56.2 °F; 224.2 K)
Autoignition temperature	260.0 °C (500.0 °F; 533.1 K)
Explosive limits	1.5–7.8%[4]
Lethal dose or concentration (LD, LC):
LD50 (median dose)	3 g kg−1 (dermal, rabbit) 5 g kg−1 (oral, mouse)
LC50 (median concentration)	130,000 mg/m3 (mouse, 30 min) 128,200 ppm (mouse, 37 min) 325,000 mg/m3 (mouse, 2 hr)[5]
NIOSH (US health exposure limits):
PEL (Permissible)	TWA 1000 ppm (2950 mg/m3)[4]
REL (Recommended)	TWA 120 ppm (350 mg/m3) C 610 ppm (1800 mg/m3) [15-minute][4]
IDLH (Immediate danger)	1500 ppm[4]
Related compounds
Related alkanes	Butane Butyl iodide Hexane
Supplementary data page
Pentane (data page)
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa). Y verify (what is YN ?) Infobox references

Close

Pentanes are components of some fuels and are employed as specialty solvents in the laboratory. Their properties are very similar to those of butanes and hexanes.

Pentanes are some of the primary blowing agents used in the production of polystyrene foam and other foams. Usually, a mixture of n-, i-, and increasingly cyclopentane is used for this purpose.

Acid-catalyzed isomerization gives isopentane, which is used in producing high-octane fuels.^[7]

Because of their low boiling points, low cost, and relative safety, pentanes are used as a working medium in geothermal power stations and organic Rankine cycles. It is also used in some blended refrigerants.

Pentanes are solvents in many ordinary products, e.g. in some pesticides.^[8]

Pentanes are relatively inexpensive and are the most volatile liquid alkanes at room temperature, so they are often used in the laboratory as solvents that can be conveniently and rapidly evaporated. However, because of their nonpolarity and lack of functionality, they dissolve only nonpolar and alkyl-rich compounds. Pentanes are miscible with most common nonpolar solvents such as chlorocarbons, aromatics, and ethers.

They are often used in liquid chromatography.

The boiling points of the pentane isomers range from about 9 to 36 °C. As is the case for other alkanes, the more thickly branched isomers tend to have lower boiling points.

The same tends to be true for the melting points of alkane isomers, and that of isopentane is 30 °C lower than that of n-pentane. However, the melting point of neopentane, the most heavily branched of the three, is 100 °C higher than that of isopentane. The anomalously high melting point of neopentane has been attributed to the tetrahedral molecules packing more closely in solid form; this explanation is contradicted by the fact that neopentane has a lower density than the other two isomers,^[9] and the high melting point is actually caused by neopentane's significantly lower entropy of fusion.

The branched isomers are more stable (have lower heat of formation and heat of combustion) than n-pentane. The difference is 1.8 kcal/mol for isopentane, and 5 kcal/mol for neopentane.^[10][11]

Rotation about two central single C-C bonds of n-pentane produces four different conformations.^[12]

Like other alkanes, pentanes are largely unreactive at standard room temperature and conditions - however, with sufficient activation energy (e.g., an open flame), they readily oxidize to form carbon dioxide and water:

C₅H₁₂ + 8 O₂ → 5 CO₂ + 6 H₂O + heat/energy

Like other alkanes, pentanes undergo free radical chlorination:

C₅H₁₂ + Cl₂ → C₅H₁₁Cl + HCl

Without zeolite catalysts, such reactions are unselective, so with n-pentane, the result is a mixture of the 1-, 2-, and 3-chloropentanes, as well as more highly chlorinated derivatives. Other radical halogenations can also occur.

Pentane is produced by fractional distillation of petroleum and purified by rectification (successive distillations).^[13]

It occurs in alcoholic beverages and in hop oil.^[13] It is a component of exhaled breath for some individuals. A degradation product of unsaturated fatty acids, its presence is associated with some diseases and cancers.^[14]