A General Approach

The rate equation involves a mathematical expression describing the rate of progress of the reaction. To predict the size of the reactor required in achieving a given degree of conversion of reactants and a fixed output of the product, the following information is required [Pg.262]

Composition changes Temperature changes Mixing patterns Mass transfer Heat transfer [Pg.262]

Introduction to Reactor Design Fundamentals for Ideal Systems 263 [Pg.263]

Information on the composition and temperature changes is obtained from the rate equation, while the mixing patterns are related to the intensity of mixing and reactor geometry. Heat transfer is referred to as the exothermic or endothermic nature of the reactions and the mass transfer to the heterogeneous systems. [Pg.263]

Consider a well-mixed batch reactor with a key reactant A, during time t to time t + 8t, where 8t is very small. For a well-mixed batch system, assume the following [Pg.264]

Finally a general approach to synthesize A -pyrrolines must be mentioned. This is tl acid-catalyzed (NH4CI or catalytic amounts of HBr) and thermally (150°C) induced tea rangement of cyclopropyl imines. These educts may be obtained from commercial cyan> acetate, cyclopropyl cyanide, or benzyl cyanide derivatives by the routes outlined below. Tl rearrangement is reminiscent of the rearrangement of 1-silyloxy-l-vinylcyclopropancs (p. 7 83) but since it is acid-catalyzed it occurs at much lower temperatures. A -Pyrrolines constitut reactive enamines and may be used in further addition reactions such as the Robinson anei lation with methyl vinyl ketone (R.V. Stevens, 1967, 1968, 1971). [Pg.298]

The probabilistic nature of a confidence interval provides an opportunity to ask and answer questions comparing a sample s mean or variance to either the accepted values for its population or similar values obtained for other samples. For example, confidence intervals can be used to answer questions such as Does a newly developed method for the analysis of cholesterol in blood give results that are significantly different from those obtained when using a standard method or Is there a significant variation in the chemical composition of rainwater collected at different sites downwind from a coalburning utility plant In this section we introduce a general approach to the statistical analysis of data. Specific statistical methods of analysis are covered in Section 4F. [Pg.82]

At Smith Kline French a general approach to cephalosporin and penicillin nuclear analogs was developed that utilizes a monocyclic /3-lactam (59) with the correct cis stereochemistry as a key intermediate. This is prepared by reaction of the mixed anhydride of azidoacetic acid and trifluoroacetic acid with imine (58) followed by oxidative removal of the dimethoxybenzyl group. This product could be further elaborated to intermediate (60) which, on reaction with a -bromoketones, provides isocephalosporins (61). These nuclear analogs displayed antibacterial properties similar to cephalosporins (b-79MI51000). [Pg.295]

A Generalized Approach to Power Supplies Introducing the Building-block Approach to Power Supply Design 8... [Pg.271]

One can to outline a general approach for medium selection along with a test sequence applicable to a large group of filter media of the same type. There are three methods of filter media tests laboratory- or bench-scale pilot-unit, and plant tests. The laboratory-scale test is especially rapid and economical, but the results obtained are often not entirely reliable and should only be considered preliminary. Pilot-unit tests provide results that approach plant data. The most reliable results are often obtained from plant trials. [Pg.149]

The [CBTJi open circuit plant—a general approach... [Pg.39]

More recent examples have employed a milder reagent system, triphenyl-phosphine and dibromotetrachloroethane to generate a bromo-oxazoline, which is subsequently dehydrohalogenated. Wipf and Lim utilized their method to transform intermediate 11 into the 2,4-disubstituted system of (+)-Hennoxazole k Subsequently, Morwick and coworkers reported a generalized approach to 2,4-disubstituted oxazoles from amino acids using a similar reagent combination, triphenylphosphine and hexachloroethane. ... [Pg.250]

The aim is to give a general approach which can be followed when total energies are calculated by both semi-empirical and ab initio methods. [Pg.339]

Soil has been defined in many ways, often depending upon the particular interests of the person proposing the definition. In discussion of the soil as an environmental factor in corrosion, no strict definitions or limitations will be applied rather, the complex interaction of all earthen materials will come within the scope of the discussion. It is obvious only a general approach to the topic can be given, and no attempt will be made to give full and detailed information on any single facet of the topic. [Pg.377]

Depending upon the substitution pattern, a thermal valence isomerization of 1,4-dioxocins 4 to the tricyclic jyn-benzene dioxides (xyn-3,8-dioxatricyclo[5.1,0.02-4]oct-5-enes) 3 can be detected. On the other hand, the valence isomerization of sin-benzene dioxides (anti-benzene dioxides do not undergo such rearrangements) provides a general approach to 1,4-dioxocins 4. [Pg.562]

Legocki, R. P., Legocki, M., Baldwin, T. O., and Szalay, A. A. (1986). Bioluminescence in soybean root nodules demonstration of a general approach to assay gene expression in vivo by using bacterial luciferase. Proc. Natl. Acad. Sci. USA 83 9080-9084. [Pg.414]

A different kind of triazine, 3,5,6-trisubstituted 1,2,4-triazines 166, were prepared by reaction of 1,2-diketones 164 with acyl hydrazide in the presence of ammonium acetate and acetic acid at 180 °C for 5 min under microwave irradiation in a sealed tube [107]. Different substituents can be introduced in the final triazines providing a general approach for this kind of heterocycles (Scheme 59). [Pg.244]

A general approach to the problem of identification, should more definitive detectors not be available, is to change the chromatographic system , which in the case of HPLC is usually the mobile phase, and redetermine the retention parameter. The change obtained is often more characteristic of a single analyte than is the capacity factor with either of the mobile phases. [Pg.38]

This section develops a general approach to data representation and describes some of its features. [Pg.214]

A general approach was developed by G.E.P. Box and G.M. Jenkins (S) which combines these various methods into an analysis which permits choice of the most appropriate model, checks the forecast precision, and allows for interpretation. The Box-Jenkins analysis is an autoregressive integrated moving average model (ARIMA). This approach, as implemented in the MINITAB computer program is one used for the analyses reported here. [Pg.91]

A general approach to the synthesis of enantiomerically pure y, as weU as y " -amino acids has been developped by Brenner and Seebach [206, 207, 230]. It involves the Michael addition of Ti-enolates generated from acyl-oxazohdin-2-ones to nitroolefms in the presence of a Lewis acid (TiCU, Et2AlCl) as the key step... [Pg.86]

A more general route to 4-acetoxy-l,3-dioxanes utilizes the reductive acylation of l,3-dioxane-4-ones [46] (Scheme 21). l,3-Dioxane-4-ones 126 are prepared from the corresponding -hydroxy carboxylic acids. Low temperature reduction with DIBALH generates a diisobutylaluminum hemiacetal (127) which undergoes acylation in situ with AC2O in the presence of pyridine and DMAP. This method allows for the preparation of a wide range of 4-acetoxy-l,3-dioxanes, without the problem of a-epimerization. This method also represents a general approach to acylic a-acetoxy ethers, which are themselves useful synthetic intermediates [47,48]. [Pg.74]

Problem Suggest a general approach to cyclohcxaclioncs of type (32). [Pg.242]

The most important part of the approach adopted in this book is concerned with the analysis of dangerous reactions , in this chapter a forecast analysis of risks that can be caused by an interaction between two or several chemicals, or between chemicals and materials, is proposed. It will be a general approach, and its purpose is to develop a range of tools in order to forecast and quantify risks due to substance reactivity in deliberate or accidental contact. [Pg.144]

Following this observation, a general approach for the synthesis of pincer-type methylene arenium compounds was developed (Scheme 3.4). Upon reaction of the methyl rhodium (or iridium) complexes 5 with a slight excess of triflic acid, dihydrogen (not methane ) was evolved to form the methylene arenium complexes 4a.11 Thus, the methylene arenium form is clearly preferred over the benzylic M(III) form, in which the positive charge is localized at the metal center. [Pg.72]

We present a general approach for estimating relative permeability and capillary pressure functions from displacement experiments. The accuracy with which these functions are estimated will depend on the information content of the measurements, and hence on the experimental design. We determine measures of the accuracy with which the functions are estimated, and use these measures to evaluate different experimental designs. In addition to data measured during conventional displacement experiments, we show that the use of multiple injection rates and saturation distributions measured with MRI can substantially increase the accuracy of estimates of multiphase flow functions. [Pg.376]

X. -F. Yuan, M. Doi 1998, (A general approach for modelling complex fluids its application to concentrated emulsions under shear), Colloid Surf. A 144, 305. [Pg.453]

Fundamentally, FBDD is a general approach aimed at deriving high affinity ligands for macromolecular targets starting from low MW binders, which are usually identified by the use of the aforementioned biophysical techniques [1, 2, 7, 8]. [Pg.128]

This section will discuss some of the adjustable parameters in method development that are critical to successful process development. As a general approach these parameters are best examined on analytical scale before increasing the scale to something approaching production size for several reasons ... [Pg.107]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...