Allyl chloride, addition

Offurtherinterest is a synthesis of cyclopropanes from allylic chlorides. Addition of diborane to allyl chloride in ether gives a mixture of mono-, di-, and tri (y-chlo-... [Pg.104]

The additions illustrated in the equation are of commercial interest. Hydro-silylation is used for the preparation of silicone polymers. Silicone rubbers are cured through addition of silanes, a process that converts the rubber to a hard material, suitable, for example, as dental cement. The usual homogeneous catalyst is chloroplatinic acid. For supported RhCla, conversions for HSiEta addition were very poor when polystyrene was the support, but improved when the support was a phosphinated allyl chloride-Addition of HSi(Oi )3 to 1-hexene with this catalyst was efficient. [Pg.472]

Benzoic acid and naphthoic acid are formed by the oxidative carbonylation by use of Pd(OAc)2 in AcOH. t-Bu02H and allyl chloride are used as reoxidants. Addition of phenanthroline gives a favorable effect[360], Furan and thiophene are also carbonylated selectively at the 2-position[361,362]. fndole-3-carboxylic acid is prepared by the carboxylation of 1-acetylindole using Pd(OAc)2 and peroxodisulfate (Na2S208)[362aj. Benzoic acid derivatives are obtained by the reaction of benzene derivatives with sodium palladium mal-onate in refluxing AcOH[363]. [Pg.78]

Organoboranes are reactive compounds for cross-coupling[277]. The synthesis of humulene (83) by the intramolecular cross-coupling of allylic bromide with alkenylborane is an example[278]. The reaction of vinyiborane with vinyl-oxirane (425) affords the homoallylic alcohol 426 by 1,2-addition as main products and the allylic alcohol 427 by 1,4-addition as a minor product[279]. Two phenyl groups in sodium tetraphenylborate (428) are used for the coupling with allylic acetate[280] or allyl chloride[33,28l]. [Pg.347]

The reaction of allyl halides with terminal alkynes by use of PdClifFhCNji as a catalyst affords the l-halo-l,4-pentadienes 297. 7r-AlIylpalladium is not an intermediate in this reaction. The reaction proceeds by chloropalladation of the triple bond by PdCh, followed by the insertion of the double bond of the allyl halide to generate 296. The last step is the regeneration by elimination of PdCh, which recycles[148]. The cis addition of allyl chloride to alkynes is supported by formation of the cyclopentenone 299 from the addition product 298 by Ni(CO)4-catalyzed carbonylation[149]. [Pg.504]

Although alkenes typically react with chlorine and bromine by addition at room tern perature and below (Section 6 14) substitution becomes competitive at higher tempera tures especially when the concentration of the halogen is low When substitution does occur It IS highly selective for the allylic position This forms the basis of an industrial preparation of allyl chloride... [Pg.396]

Reaction Mechanism. High temperature vapor-phase chlorination of propylene [115-07-17 is a free-radical mechanism in which substitution of an allyhc hydrogen is favored over addition of chlorine to the double bond. Abstraction of allyhc hydrogen is especially favored since the allyl radical intermediate is stabilized by resonance between two symmetrical stmctures, both of which lead to allyl chloride. [Pg.33]

Metal oxides. Magnesium oxide is used to cure polychloroprene by converting its few active allylic chloride from 1,2 addition into ether cross-links. There is a synergistic effect when magnesium oxide is used in combination with t-butyl phenolic resins in solvent-borne polychloroprene adhesives. When solvent is removed, the phenolic group in the resin reacts with the magnesium oxide to cross-link [49]. [Pg.639]

The majority of catalytic enantioselective allylation reactions involve the chiral Lewis-acid-catalysed additions of allylsilanes or allylstannanes to carbonyl compounds. Monothiobinaphthol has been used by Woodward et al. as a chiral promoter in the enantioselective catalytic allylation of aryl ketones with impure Sn(allyl)4, prepared from allyl chloride, air-oxidised magnesium and SnCl4. Therefore, the allylation of arylketones in these conditions was achieved very efficiently, since the corresponding allylic alcohols were formed in... [Pg.310]

Mediated by Tin. In 1983, Nokami et al. observed an acceleration of the reaction rate during the allylation of carbonyl compounds with diallyltin dibromide in ether through the addition of water to the reaction mixture.74 In one case, by the use of a 1 1 mixture of ether/water as solvent, benzaldehyde was allylated in 75% yield in 1.5 h, while the same reaction gave only less than 50% yield in a variety of other organic solvents such as ether, benzene, or ethyl acetate, even after a reaction time of 10 h. The reaction was equally successful with a combination of allyl bromide, tin metal, and a catalytic amount of hydrobromic acid. In the latter case, the addition of metallic aluminum powder or foil to the reaction mixture dramatically improved the yield of the product. The use of allyl chloride for such a reaction,... [Pg.229]

A crystal structure of the C02 derivative of (8), K[Co(salen)( 71-C02)], haso been reported in which the Co—C bond is 1.99 A, the C—O bonds are both equivalent at 1.22 A and the O-C-O angle is 132°.125 Carboxylation of benzylic and allylic chlorides with C02 in THF-HMPA was achieved with (8) electrogenerated by controlled-potential electrolysis,126 in addition to reductive coupling of methyl pyruvate, diethyl ketomalonate and / -tolylcarbodiimide via C—C bond formation. Methyl pyruvate is transformed into diastereomeric tartrates concomitant with oxidation to the divalent Co(salen) and a free-radical mechanism is proposed involving the homolytic cleavage of the Co—C bond. However, reaction with diphenylketene (DPK) suggests an alternative pathway for the reductive coupling of C02-like compounds. [Pg.11]

Allylic chlorides can also be used as coupling partners, as shown by Lu and Liu [137]. In addition, the domino process could be used for the synthesis of benzylidene pyrrolidines, as shown for the reaction of 6/1-285 with benzylidene malonate... [Pg.408]

The complex also undergoes a variety of addition reactions with reagents such as methyl iodide, hydrochloric acid, benzoyl chloride, and allyl chloride.8 In a reaction similar to that of the decarboxylation of aldehydes, the complex will abstract CS from carbon disulfide to give the irans-thiocarbonyl complex rans-RhClCS[P(C8H6)5]2.9... [Pg.71]

If the side chain with the nucleophile is situated in the 1-position of the conjugated diene, a palladium-catalyzed spirocyclization occurs. In this case stereoselective oxa-spirocyclizations were obtained from the diene alcohols 59 and 60 (equation 23 -25)58. The reaction worked well for the formation of a tetrahydrofuran and tetrahydropyran in the spirocyclization. In the absence of chloride ions 59 gave high yields of the acetoxy oxaspirocyclic compound 61 via a 1,4-anti addition across the diene (equation 23). In the presence of stoichiometric amounts of LiCl a 1,4-syn oxychlorination took place and allylic chloride 62 was obtained (equation 24). Under chloride-free conditions, cyclohep-tadiene alcohol 60 afforded oxaspirocyclic acetate 63 (equation 25). [Pg.675]

Although the majority of allylic etherification reactions have primarily utilized allylic carboxylates or carbonates as electrophiles (and occasionally allylic chlorides), the use of allylic alcohols for this transformation would be more desirable from a practical standpoint. Reported strategies involving Pd catalysis include the use of P(OPh)3 as the ligand197 and Ti(OPf)4198 as an additive for the in situ activation of the hydoxyl group (Equation (49)).199... [Pg.663]

Halogen Addition to Unsaturated Compounds. Part XV. Benzyl and Allyl Chloride, Bromide, and Cyanide. J. chem. Soc. (London) 19S0, 812. [Pg.67]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...