Amines palladium catalyst

Allylic acetoxy groups can be substituted by amines in the presence of Pd(0) catalysts. At substituted cyclohexene derivatives the diastereoselectivity depends largely on the structure of the palladium catalyst. Polymer-bound palladium often leads to amination at the same face as the aoetoxy leaving group with regioselective attack at the sterically less hindered site of the intermediate ri -allyl complex (B.M. Trost, 1978). [Pg.164]

Water hydroly2es pure diketene only slowly to give acetoacetic acid [541-50-4] which quickly decomposes to acetone and carbon dioxide, but increasing the pH or adding catalysts (amines, palladium compounds) increases the rate of hydrolysis. The solvolysis of diketene in ammonia results in aceto acetamide [5977-14-0] if used in stoichiometric amounts (99), and P-arninocrotonarnide [15846-25-0] if used in excess (100). [Pg.478]

A better method for preparing primary amines is to use the azide synthesis, in which azjde ion, N3, is used for SN2 reaction with a primary or secondary alkyl halide to give an alkyl azide, RN3. Because alkyl azides are not nucleophilic, overalkylation can t occur. Subsequent reduction of the alkyl azide, either by catalytic hydrogenation over a palladium catalyst or by reaction with LiAlK4. then leads to the desired primary amine. Although the method works well, low-molecular-weight alkyl azides are explosive and must be handled carefully. [Pg.929]

The Suzuki reaction has been successfully used to introduce new C - C bonds into 2-pyridones [75,83,84]. The use of microwave irradiation in transition-metal-catalyzed transformations is reported to decrease reaction times [52]. Still, there is, to our knowledge, only one example where a microwave-assisted Suzuki reaction has been performed on a quinolin-2(lH)-one or any other 2-pyridone containing heterocycle. Glasnov et al. described a Suzuki reaction of 4-chloro-quinolin-2(lff)-one with phenylboronic acid in presence of a palladium-catalyst under microwave irradiation (Scheme 13) [53]. After screening different conditions to improve the conversion and isolated yield of the desired aryl substituted quinolin-2( lff)-one 47, they found that a combination of palladium acetate and triphenylphosphine as catalyst (0.5 mol %), a 3 1 mixture of 1,2-dimethoxyethane (DME) and water as solvent, triethyl-amine as base, and irradiation for 30 min at 150 °C gave the best result. Crucial for the reaction was the temperature and the amount of water in the... [Pg.21]

The N-substituted aminoacids required could be prepared by microwave-assisted reductive amination of aminoacid methyl esters with aldehydes, and although in the Westman report soluble NaBH(OAc)3 was used to perform this step, other reports have shown how this transformation can be performed in using polymer-supported borohydrides (such as polymer-supported cyanoborohydride) under microwave irradiation [90]. An additional point of diversity could be inserted by use of a palladium-catalyzed reaction if suitably substituted aldehydes had been used. Again, these transformations might eventually be accomplished using supported palladium catalysts under microwave irradiation, as reported by several groups [91-93]. [Pg.147]

The reaction of arylbromides with amines affords mostly the corresponding aromatic hydrocarbon by using palladium catalysts, but the expected substituted anilines are formed in good yields by using a nickel (II) catalyst. [Pg.240]

If, instead of a palladium catalyst, a nickel catalyst, such as the bipyridylnickel(II) bromide, is used for the arylation of amines (Fig. 7), the reduction of the aryl halide into the corresponding aromatic hydrocarbon is still present for the primary or secondary benzylamines but, the arylation into substituted anilines is the main reaction even most often the only one, for the other types of amines. [Pg.246]

Reduction of iV-(3-bromopropyl) imines gives a bromo-amine in situ, which cyclizes to the aziridine. Five-membered ring amines (pyrrolidines) can be prepared from alkenyl amines via treatment with N-chlorosuccinimide (NCS) and then BusSnH. " Internal addition of amine to allylic acetates, catalyzed by Pd(PPh3)4, leads to cyclic products via a Sn2 reaction. Acyclic amines can be prepared by a closely related reaction using palladium catalysts. Three-membered cyclic amines (aziridines)... [Pg.500]

Acid derivatives that can be converted to amides include thiol acids (RCOSH), thiol esters (RCOSR), ° acyloxyboranes [RCOB(OR )2]. silicic esters [(RCOO)4Si], 1,1,1-trihalo ketones (RCOCXa), a-keto nitriles, acyl azides, and non-enolizable ketones (see the Haller-Bauer reaction 12-31). A polymer-bound acyl derivative was converted to an amide using tributylvinyl tin, trifluoroacetic acid, AsPh3, and a palladium catalyst. The source of amine in this reaction was the polymer itself, which was an amide resin. [Pg.512]

Other nucleophiles add to conjugated systems to give Michael-type products. Aniline derivatives add to conjugated aldehydes in the presence of a catalytic amount of DBU (p. 488). Amines add to conjugated esters in the presence of InCla, La(OTf)3, or YTb(OTf)3 at 3kbar, for example, to give P-amino esters. This reaction can be initiated photochemically. An intramolecular addition of an amine unit to a conjugated ketone in the presence of a palladium catalyst, or... [Pg.1023]

The groups R2N and Cl can be added directly to alkenes, allenes, conjugated dienes, and alkynes, by treatment with dialkyl-V-chloroamines and acids. " These are free-radical additions, with initial attack by the R2NH- radical ion. " N-Halo amides (RCONHX) add RCONH and X to double bonds under the influence of UV light or chromous chloride. " Amines add to allenes in the presence of a palladium catalyst. ... [Pg.1045]

The reductive amination of ketones can be carried out under hydrogen pressure in the presence of palladium catalysts. However, if enantiopure Q -aminoketones are used, partial racemization of the intermediate a-amino imine can occur, owing to the equilibration with the corresponding enam-ine [102]. Asymmetric hydrogenation of racemic 2-amidocyclohexanones 218 with Raney nickel in ethanol gave a mixture of cis and trans 1,2-diamino cyclohexane derivatives 219 in unequal amounts, presumably because the enamines are intermediates, but with excellent enantioselectivity. The two diastereomers were easily separated and converted to the mono-protected cis- and trans- 1,2-diaminocyclohexanes 220. The receptor 221 has been also synthesized by this route [103] (Scheme 33). [Pg.39]

The palladium catalyst is essential in this reaction, as was shown in control experiments to make sure that this was not a direct nucleophilic addition of the amine to the electron-poor (regarding the low lying LUMO ) cyclobutadiene ligand. A series of amino-substituted cyclobutadiene complexes have been synthesized by this methodology [29]. [Pg.139]

The removal of carbobenzyloxy (Cbz or Z) groups from amines or alcohols is of high interest in the fine chemicals, agricultural and pharmaceutical industry. Palladium on activated carbon is the catalyst of choice for these deprotection reactions. Nitrogen containing modifiers are known to influence the selectivity for certain deprotection reactions. In this paper we show the rate accelerating effect of certain N-containing modifiers on the deprotection of carbobenzyloxy protected amino acids in the presence of palladium on activated carbon catalysts. The experiments show that certain modifiers like pyridine and ethylenediamine increase the reaction rate and therefore shorten the reaction times compared to non-modified palladium catalysts. Triethylamine does not have an influence on the rate of deprotection. [Pg.493]

Hartwig and Buchwald have developed a new methodology for arylation of amines or phenols with aryl halides and palladium catalysts.17 This reaction provides a very useful strategy for the preparation of various heterocyclic compounds such as phenazines, as shown in Scheme 9.4.18... [Pg.306]

Reactions of heterocyclic amines 208 with 2-chloro-3-iodopyridine 209 in the presence of a palladium catalyst provide dipyridoimidazole and its benzo- and aza-analogues 210. The synthesis represents the first tandem double palladium-catalyzed amination reaction (Equation 23) <2004CC2466>. [Pg.992]

Chang et al. reported a mild tandem intramolecular hydroamination of yne amines to form an endo-adduct intermediate, which reacts with electron-deficient azides to produce cyclic amidines <06JA12366>. Selected examples of an interesting synthetic route to tropene derivatives 165 via a dual hydroamination strategy is shown below. This one-step reaction makes use of a palladium catalyst and takes place by sequential intermolecular hydroamination of cycloheptatriene with aryl, heteroaryl, and primary alkyl amines to generate intermediate 166, followed by transannular intramolecular hydroamination <06JA8134>. [Pg.336]

An even simpler protocol for performing nucleophilic substitutions (aminations) and Suzuki reactions in one pot was reported by the Organ group for the generation of a 42-member library of styrene-based nicotinic acetylcholine receptor (nAChR) antagonists (Scheme 6.21) [49]. After considerable experimentation, the authors found that simultaneous nucleophilic displacement and Suzuki coupling could be carried out very effectively by charging the microwave process vessel with the palladium catalyst (0.5 mol% palladium-on-charcoal), the boronic acid [R1B(OH)2], the... [Pg.120]

Independent investigations by Maes and coworkers have involved the use of commercially available and air-stable 2-(dicydohexylphosphanyl)biphenyl (ligand B) as a ligand system for the successful and rapid coupling of (hetero)aryl chlorides with amines under microwave Buchwald-Hartwig conditions (0.5-2 mol% palladium catalyst) [129, 130]. Both methods provide very high yields of products within an irradiation time of 10 min. [Pg.150]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...