Analytical Fitting

The anal3Aical fitting procedure involves the explicit evaluation of all the matrix elements of G and its subsequent inversion, which is achieved by diagonalization. We have implemented several methods for the diagonalization step. Initially we employed singular value decomposition (SVD) (Press et al., 1992) by setting the inverse of the eigenvalue to zero if it is below a certain cutoff. However, this method produces undesirable numerical instabilities (noise) when [Pg.272]

In the current implementation we employ the Tikhonov regularization method (Press et al., 1992. This approach is similar to the constrained density fitting algorithm of Misquitta and Stone (Misquitta and Stone, 2006. Here, the redundant basis set contributions are penalized by minimizing Eseit + resulting [Pg.273]

For problematic systems we also implemented the damped Coulomb operator 0 = erfc fir)/r proposed by (Jung et al., 2005 to attenuate the near singular behavior due to long range interactions present in G. In our studies we observed that noise is still a problem for some systems. The noise in the fit is known to arise due to the attempt of the ABSs to fit the density at the nuclear cores (Cisneros et al., 2005b, 2006a. [Pg.273]

Hu C H and Thakkar A J 1996 Potential energy surface for interactions between N2 and He ab initio calculations, analytic fits, and second virial coefficients J. Chem. Phys. 104 2541... [Pg.214]

This integral equation can be solved by expansion of the integrand in bipolar coordmates [2, 3], Further improvement to the PY equation can be obtamed by analytical fit to simulation studies as described below. [Pg.563]

The full dynamical treatment of electrons and nuclei together in a laboratory system of coordinates is computationally intensive and difficult. However, the availability of multiprocessor computers and detailed attention to the development of efficient software, such as ENDyne, which can be maintained and debugged continually when new features are added, make END a viable alternative among methods for the study of molecular processes. Eurthemiore, when the application of END is compared to the total effort of accurate determination of relevant potential energy surfaces and nonadiabatic coupling terms, faithful analytical fitting and interpolation of the common pointwise representation of surfaces and coupling terms, and the solution of the coupled dynamical equations in a suitable internal coordinates, the computational effort of END is competitive. [Pg.233]

Direct dynamics attempts to break this bottleneck in the study of MD, retaining the accuracy of the full electronic PES without the need for an analytic fit of data. The first studies in this field used semiclassical methods with semiempirical [66,67] or simple Hartree-Fock [68] wave functions to heat the electrons. These first studies used what is called BO dynamics, evaluating the PES at each step from the elech onic wave function obtained by solution of the electronic structure problem. An alternative, the Ehrenfest dynamics method, is to propagate the electronic wave function at the same time as the nuclei. Although early direct dynamics studies using this method [69-71] restricted themselves to adiabatic problems, the method can incorporate non-adiabatic effects directly in the electionic wave function. [Pg.255]

One could try to replace the present tables of atomic SCF functions by analytic approximations20 21 24 which then may be the starting point for the energy calculations. It turns out, however, that different analytic fits are possible which correspond to slightly different energies, but there is at least a unique connection between the start and the end in this case. [Pg.237]

In Table 3.5, the low-temperature thermal conductivity k of some materials of cryogenic interest is reported together with an analytic fit. [Pg.96]

Fig. 10. a-c. Sections through the energy hypersurfaces of the systems Li+-OH2, Na+-OHg and K+-OH2. Lower part section in the plane of the water molecule Upper part section perpendicular to the plane of the water molecule containing the C2u-axis. The spacing of the lines is 5.0 kcal/mole (analytical fit from Ref. 206>)... [Pg.63]

A.I. Godunov, P.B. Ivanov, On analytical fits for electron impact ionization cross sections, Phys. Scr. 59 (1999) 277. [Pg.377]

Fig. 18. Best analytical fits to experimental extrusion pressure — extrusion ratio Rj, data...

Nevertheless, it is possible that such analytical fittings of the catalyst decay curve are too oversimplified to take into account the complexity of the phenomena which take place during polymerization. On the other hand, the kinetic studies are only able to measure the average constants of the reaction and not those for each individual species. Thus, although the mechanism of deactivation of the active centers, or part thereof, has clearly been shown to be of a chemical nature, it can only be explained in hypothetical terms. In agreement with the 2nd order decay law they had proposed, Keii and Doi98 99) speculated on a bimolecular disproportionation of the active species with a consequent reduction of Ti3+ to Ti2 1 due to the action of the cocatalyst. [Pg.32]

This reaction proceeds adiabatically via the two lowest potential energy surfaces, and with a degeneracy factor of 1/3 each. These surfaces are usually obtained by analytically fitting the energies obtained from an ab initio computational quantum chemistry calculation at various nuclear positions. In Ref. 67, the contracted configuration interaction (CCI) ab initio data of Walch and Jaffe was used for both potential energy surfaces. The details of the analytical representation of the and surfaces can be found in Refs. 67 and 70, respectively. [Pg.107]

Figure 9 Examples of dissolved silica profiles in a variety of marine sediments. The lines through the data are simple analytical fits of the data to the relation = al (1 — + a3 (see text). AESOPS pro-...

Recently, the sapt approach has been applied (32) to compute the interaction-induced polarizability for the helium diatom. The computed polarizability invariants have been analytically fitted, and used in quantum-dynamical calculations of the binary collision-induced Raman spectra. The results of the dynamical calculations are summarized in Fig. 1. [Pg.126]

The first preliminary calculations for coplanar H + H2 were published by Saxon and Light (1971). This system is favourable for exploratory calculations because of the large rotational spacing of H2. Total energies were varied from 13 to 17-5 kcal/mole and total angular momenta from 0 to 12 h. Calculations were made for an analytical fit to the Shavitt et al. (1968) surface, within a manifold of 19 rotational states (from j = — 9 to 7 = 9)... [Pg.32]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...