Column reactors

External and internal loop air-lifts and bubble column reactors containing a range of coalescing and non-Newtonian fluids, have been studied (52,53). It was shown that there are distinct differences in the characteristics of external and internal loop reactors (54). Overall, in this type of equipment... [Pg.336]

Bubble columns in series have been used to establish the same effective mix of plug-flow and back-mixing behavior required for Hquid-phase oxidation of cyclohexane, as obtained with staged reactors in series. WeU-mixed behavior has been established with both Hquid and air recycle. The choice of one bubble column reactor was motivated by the need to minimize sticky by-products that accumulated on the walls (93). Here, high air rate also increased conversion by eliminating reaction water from the reactor, thus illustrating that the choice of a reactor system need not always be based on compromise, and solutions to production and maintenance problems are complementary. Unlike the Hquid in most bubble columns, Hquid in this reactor was intentionally weU mixed. [Pg.524]

Direct Chlorination of Ethylene. Direct chlorination of ethylene is generally conducted in Hquid EDC in a bubble column reactor. Ethylene and chlorine dissolve in the Hquid phase and combine in a homogeneous catalytic reaction to form EDC. Under typical process conditions, the reaction rate is controlled by mass transfer, with absorption of ethylene as the limiting factor (77). Ferric chloride is a highly selective and efficient catalyst for this reaction, and is widely used commercially (78). Ferric chloride and sodium chloride [7647-14-5] mixtures have also been utilized for the catalyst (79), as have tetrachloroferrate compounds, eg, ammonium tetrachloroferrate [24411-12-9] NH FeCl (80). The reaction most likely proceeds through an electrophilic addition mechanism, in which the catalyst first polarizes chlorine, as shown in equation 5. The polarized chlorine molecule then acts as an electrophilic reagent to attack the double bond of ethylene, thereby faciHtating chlorine addition (eq. 6) ... [Pg.417]

A significant advantage of immobilized enzymes is the total absence of catalytic activity in the product. Moreover, the degree of substrate-to-product conversion can be controlled during processing, eg, by adjusting the flow rate through a packed-bed column reactor of immobilized enzyme. [Pg.291]

The absorption is carried out by countercurrent passage of ethylene through 95—98% sulfuric acid in a column reactor at 80°C and 1.3—1.5 MPa (180—200 psig) (41). The absorption is exothermic, and cooling is required (42) to keep the temperatures down and thereby limit corrosion problems. The absorption rate increases when ethyl hydrogen sulfate is present in the acid (43—46). This increase is attributed to the greater solubiUty of ethylene in ethyl hydrogen sulfate than in sulfuric acid. [Pg.404]

The situation becomes more complicated when the reaction is IdneticaUy controlled and does not come to complete-chemical equilibrium under the conditions of temperature, hquid holdup, and rate of vaporization in the column reactor. Venimadhavan et al. [AIChE J., 40, 1814 (1994)] and Rev [Jnd. Eng. Chem. Res., 33, 2174 (1994)] show that the existence and location of reactive azeotropes is a function of approach to equilibrium as well as the evaporation rate. [Pg.1321]

Other Effects Stream concentration can have important effects on corrosion rates. Unfortunately, corrosion rates are seldom linear with concentration over wide ranges. In equipment such as distillation columns, reactors, and evaporators, concentration can change continuously, makiug prediction of corrosion rates rather difficult. Concentration is important during plant shutdown presence of moisture that collects during cooling can turn innocuous chemicals into dangerous corrosives. [Pg.2422]

Tube and shell heat exchangers, small distillation columns, reactors, valves, pumps and other items are available in impregnated grapliite. Graphite can be joined only by cementing, which embrittles on aging. It is prone to mechanical damage, particularly when subjected to tensile stresses. [Pg.102]

Deckwer, W.D., 1992. Bubble column reactors. John Wiley and Sons. [Pg.304]

Shah, Y.T., Kelkar, B.G., Godbole, S.P. and Deckwer, W.D., 1982. Design parameter estimations for bubble column reactors. American Institute of Chemical Engineers Journal, 28, 353. [Pg.322]

BLEND STATION DRYING COLUMN REACTOR (SEVERAL)... [Pg.355]

Figure A8.14 Closed column reactor for the production of L-alanine. 1) reactor 2) plunger pump 3) pressure control valve 4) reservoir 5) substrate tank 6) pressure gauge 7) safety valve 8) heat exchanger.

Virtually crosslinked (VC) products, 201 Viscometry, of polyamides, 161-162 Viscosity, molecular weight and, 3 VK column reactor, 175 Volatile organic compounds (VOCs), 206, 207... [Pg.604]

A Chromatograph System Including a Post-Column Reactor... [Pg.245]

Post-column reaction is a common feature of many special types of analyses, the most well-known being the amino acid analyzer that uses ninhydrin with a post-column reactor to detect the separated amino acids. In general, derivatization and post-column reactor systems are techniques of last resort. In some applications they are unavoidable, but if possible, every effort should made to find a suitable detector for the actual sample materials before resorting to derivatization procedures. [Pg.247]

The reactor can have a number of designs depending on individual requirements but in general both stirred tank and packed column reactors are viable, glass is the normal material of construction. After leaving the reactor, the bromine is separated from the aqueous solution and purified by standard techniques to get reagent ready for recycle into the process. Having removed bromide from the effluent stream and only added water and a small amount of sulphate, the final effluent is much cleaner. [Pg.360]

FIGURE 11.4 Typical tray in a tray column reactor used for acid-gas scrubbing. [Pg.393]

Sufficient engineering data for designing reactors for three-phase processes are available. A column reactor with gravitational liquid downflow was industrially proven. An MLR with forced liquid downflow with ejector was also well studied. Dedicated catalysts for particular processes must be, however, worked out. [Pg.204]

This study investigates the hydrodynamic behaviour of an aimular bubble column reactor with continuous liquid and gas flow using an Eulerian-Eulerian computational fluid dynamics approach. The residence time distribution is completed using a numerical scalar technique which compares favourably to the corresponding experimental data. It is shown that liquid mixing performance and residence time are strong functions of flowrate and direction. [Pg.669]

Many industrial processes which employ bubble column reactors (BCRs) operate on a continuous liquid flow basis. As a result these BCR s are a substantially more complicated than stationary flow systems. The design and operation of these systems is largely proprietary and there is, indeed a strong reliance upon scale up strategies [1]. With the implementation of Computational Fluid Dynamics (CFD), the associated complex flow phenomena may be anal)rzed to obtain a more comprehensive basis for reactor analysis and optimization. This study has examined the hydrodynamic characteristics of an annular 2-phase (liquid-gas) bubble column reactor operating co-and coimter-current (with respect to the gas flow) continuous modes. [Pg.669]

An investigation into the applicability of numerical residence time distribution was carried out on a pilot-scale annular bubble column reactor. Validation of the results was determined experimentally with a good degree of correlation. The liquid phase showed to be heavily dependent on the liquid flow, as expected, but also with the direction of travel. Significantly larger man residence times were observed in the cocurrent flow mode, with the counter-current mode exhibiting more chaimeling within the system, which appears to be contributed to by the gas phase. [Pg.672]

Zahradnik, J. and M. Fialova, The effect of bubbling regime on gas and liquid phase mixing in bubble column reactors. Chemical Engineering Science, 1996. 51(10) p. 2491-2500. [Pg.672]

Two basically different reactor technologies are currently in operation low temperature and high temperature. The former operates at -220 °C and 25-45 bar, employing either a multitubular, fixed bed (i.e. trickle bed) reactor or a slurry bubble column reactor with the catalyst suspended in the liquid hydrocarbon wax product. [Pg.325]

Stirred Tank Reactor (STR) Bubble Column Reactor (BCR) Continuous Reactor (CR) Electrochemical (EC). [Pg.4]

In a distillation column reactor (DCR), reaction and distillation occur simultaneously. This technology is also referred to as reactive distillation, or, if a catalyst is involved, as catalytic distillation. DCRs offer distinct advantages of exploiting the exothermicity of reactions, such... [Pg.129]

Choi and Won (1999) have reported a very u.seful strategy of recovering relatively nonvolatile lactic acid (e.g. from fermentation of carbohydrates) as volatile methyl lactate using a cationic ion-exchange resin as the catalyst. In another column reactor the methyl lactate is hydrolysed, using a cationic ion-exchange resin as the catalyst, to lactic acid and methanol, and the latter is recycled. [Pg.132]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...