Crystal Cell

A nematic liquid crystal cell, based on Merck Licrilite E202, was used in these experiments. The rod like liquid crystal molecules preferentially aligned themselves with each other and to an alignment surface in the liquid crystal device. Any birefringence. An, was given as the difference between the two orthogonal refractive indices. As a consequence, any resulting... [Pg.680]

Figure 2. Schematic of the experimental arrangement used for inspection of aluminium plate. Lenses are shown as LI and L2, mirrors as Ml, M2 and M3, and liquid crystal cell as LC...

If we compare with figure C2.2.I I, we can see that this defonnation involves bend and splay of the director field. This field-induced transition in director orientation is called a Freedericksz transition [9, 106, 1071. We can also define Freedericksz transitions when the director and field are both parallel to the surface, but mutually orthogonal or when the director is nonnal to the surface and the field is parallel to it. It turns out there is a threshold voltage for attaining orientation in the middle of the liquid crystal cell, i.e. a deviation of the angle of the director [9, 107]. For all tliree possible geometries, the threshold voltage takes the fonn [9, 107]... [Pg.2561]

An interesting report on l-phenyl-3-methyl-5-pyrazolone (49) shows that when two tautomers are of comparable energy they could both be present in the crystal cell (73CSC469). In this case NH and OH tautomers, (49a) and (49b) respectively, coexist in the crystal (Section 4.04.1.5.2). [Pg.181]

MIR), requires the introduction of new x-ray scatterers into the unit cell of the crystal. These additions should be heavy atoms (so that they make a significant contribution to the diffraction pattern) there should not be too many of them (so that their positions can be located) and they should not change the structure of the molecule or of the crystal cell—in other words, the crystals should be isomorphous. In practice, isomorphous replacement is usually done by diffusing different heavy-metal complexes into the channels of preformed protein crystals. With luck the protein molecules expose side chains in these solvent channels, such as SH groups, that are able to bind heavy metals. It is also possible to replace endogenous light metals in metal-loproteins with heavier ones, e.g., zinc by mercury or calcium by samarium. [Pg.380]

Monomer addition under radical propagation conditions leads to mainly an atactic configuration. As a consequence, radical polymerisations of asymmetric vinyl polymers usually lead to amorphous materials. However, if the substituent is small enough to enter into the crystal cell, atactic vinyl polymers can crystallise (an example is poly(vinyl fluoride)). [Pg.37]

The parameters of an elementary crystal cell for initial and finite state are practically identical. For example, interplanar distance C= (6.718 + 0.007)T0"8 cm for NGZ (GAK-1 grade) and NGF dos not change during cycling. [Pg.402]

It is noticed that the improvement of solar cells is remarkable, and the efficiencies of Si-single crystal cell and the poly crystalline cell reach 17 % and 12.5 %, respectively. The average cost of solar cell module is 3 per watt, which can be competitive with other conventional power sources [8],... [Pg.4]

In the early days of X-ray crystallography, the majority of research was performed by mineralogists. And it was in their studies of low molecular weight inorganics that the ideas about the relationship of molecular and crystal cell size was developed. [Pg.31]

An advantage of the constant composition technique is that relatively large extents of growth and enhanced crystallinity can be achieved at low supersaturations. Improved crystallinity of the particles during crystallization is reflected in lower specific surface areas of the solid phases x-ray powder diffractograms of the solid phases removed from the crystallization cell also show increases in sharpness. Experiments in which crystal growth was allowed to proceed until five or six times the amount of... [Pg.654]

This constitutes an interesting industrial problem, since compounds with chemical formula LixMn204 (crystal cell cubic, 0.82 nm space group Fd3m) are found to have interesting electrochemical properties depending on the Li stoichiometry in the structure". This material has a wide potential and it is used for Lithium -based batteries in cell phone applications. [Pg.179]

Tanaka, Chatani, and Tadokoro improved this model by refining the crystal structure of polyisobutene (182). The resulting structure is a 2/1 helix in which the structural unit contains four nonequivalent monomer units. In the crystal cell there are always eight monomer units arranged in three turns but the 8/3 helical symmetry is no longer retained. This example represents one of the most notable exceptions to the equivalence principle. Displacement from the exact helical conformation is small, however, and all the pairs of torsion angles fall inside the same energy well. [Pg.52]

The magnetite crystals are well developed (euhedral), and this ensures that they act as single magnetic domains (SD) and produce remanent magnetization in sediments. The average number of magnetite crystals/cell in 220 cells of the microaero-... [Pg.481]

Table 1. Crystal cell parameters for various salts of 2a". [Pg.73]

Crystal Locations, Planes, and Directions. In order to calculate such important quantities as cell volumes and densities, we need to be able to specify locations and directions within the crystal. Cell coordinates specify a position in the lattice and are indicated by the variables u, v, w, separated by commas with no brackets ... [Pg.38]

The dimensions of a nitrocellulose crystal cell depend on the degree of nitration. Values from the papers of Mathieu [14, 34] characterizing native cellulose and various nitrocelluloses are quoted in Table 38. [Pg.236]

According to Mathieu, trinitrocellulose crystals belong to the orthorhombic system, the dimensions of the crystal cell being a = 12.40 A,b — 25.4 A, c = 9.0 A, angle (S = 90°. Similar figures have been reported by Happey [15]. [Pg.236]

A plane projection of the crystal cell of cellulose (a) and of cellulose trinitrate b) is outlined by the schemes in Fig. 84. Much interest was aroused in the results... [Pg.238]

Tables 2.1 and 2.2a provide details of the geometry of the hydrate cages (number of cavities per unit cell, average cavity radius) and crystal cell structures (space group, lattice parameters, cell formula, atomic positions), respectively. Table 2.2b lists the atomic coordinates for structures I, II, and H.

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...