Dust emission

Beneficiation faciUties require air and water pollution control systems, including efficient control of dust emissions, treatment of process water, and proper disposal of tailings (see AiRPOLLUTlON CONTROLMETHODS). In handling finished fluorspar, operators must avoid breathing fluorspar dust and contacting fluorspar with acids. Proper disposal of spills and the use of respirators and other personnel protective equipment must be observed. Contact with fluorspar may irritate the skin and eyes. [Pg.175]

BS 3405, Simplified Methodsfor Measurement of Grit and Dust Emission from Chimneys, British Standards, London, 1961. [Pg.307]

In some circumstances, states may consider trading open dust emissions for particulates (although EPA warns that this type of trading will be difficult). [Pg.2158]

A dust eloud eomprising a distribution of partiele sizes soon fraetionates, e.g. visible matter settles to the ground in a few minutes. Henee the size distribution of airborne partieles may differ signifieantly with time and from that of the souree material. (This is partieularly relevant to oeeupational hygiene measurements involving toxie dust emissions.)... [Pg.50]

Urea Plants - In urea plants, wet scrubbers or fabrie filters are used to control fugitive emissions from prilling towers fabric filters are used to eontrol dust emissions from bagging operations. These equipment are an integral part of the operations, to retain product. New urea plants should achieve levels of particulate matter in air emissions of less than 0.5 kg/t of product for both urea and ammonia. [Pg.66]

Ammonium Nitrate Plant 7. Prill lower reduce microprill formation and reduce carryover of fines through entrainment. 8. Materials handling where feasible use covers and hoods on conveyors and transition points. Good cleanup practices must be in place to minimize contamination of stormwater mnoff from the plant property. 9. Granulators reduce dust emissions from the disintegration of granules. [Pg.68]

In a fertilizer plant, the main source of potential air pollution is dusts and fiunes from spills, operating upsets, and dust emissions. It is essential that tight operating procedures be in place and that close attention be paid to constant cleanup of spills and to other housecleaning measures. [Pg.69]

Maintain a water cover to reduce radon gas release and dust emissions. [Pg.69]

Reduce dust emissions at furnaces by covering iron runners when tapping the blast furnace and by using nitrogen blankets during tapping. [Pg.127]

Table 8 provides a list of pollution prevention practices for reducing air emissions in mini steel mills. Standard treatment technologies for air emissions are as follows. Dust emission control technologies include cyclones, baghouses, and ESPs. Scrubbers are used to control acid mists. [Pg.129]

Use continuous casting for semifinished and finished products wherever feasible. In some cases, continuous charging may be feasible and effective for controlling dust emissions. [Pg.129]

Use bottom tapping of EAFs to prevent dust emissions. [Pg.129]

Bauxite and limestone handling and storage dust emissions are controlled by baghouses. [Pg.140]

Lime kilns dust emissions are controlled by baghouse systems. Kiln fuels can be selected to reduce SO, emissions however, this is not normally a problem, since most of the sulfur dioxide that is formed is absorbed in the kiln. [Pg.140]

Dust emissions result from the creation of local airflow caused by wind and from air displacement and entrainment resulting from material movement. [Pg.908]

Unit process Dust emission per unit process reference flow, O (kg/ton or kg/MJ) Unit process reference flow per product system reference flow, F (ton/ton or MJ/ton) Dust emission per product system reference flow, D x F (kg/ton steel-sheet)... [Pg.1361]

Section 1 of the Act prohibits dark smoke from trade premises (the 1956 Act only controlled smoke from chimneys). Bonfires are thus now included. Section 2 controls the rate of grit and dust emission from furnaces and the Minister may make Regulations. These are known as the Clean Air (Emission of Grit and Dust from Furnaces) Regulations 1971 and the Clean Air (Emission of Grit and Dust from Furnaces) (Scotland) Regulations 1971. [Pg.755]

Schedule 2 furnaces are rated by heat input and are indirect heating appliances or appliances in which the combustion gases are in contact with the material being heated (but the material does not contribute to the grit and dust). These are a heat input in the range 1.25 to 575 million BTUs. Tables of permissible grit and dust emission rates are given. [Pg.755]

The dust suppressant method uses chemicals to (temporarily) strengthen bonds between soil particles and reduce fugitive dust emissions from inactive waste piles. Dust suppressant is expected to be 100% effective for a period of one to four weeks if the use of chemical is appropriate and undisturbed. Dust suppressants can also be used to control dust from work areas however, it is less effective and requires frequent reapplications. [Pg.611]

The water spraying method is most commonly used to reduce fugitive dusts emission by spraying water onto the exposed surface area, for example, along active travel paths, excavation areas, and truck boxes loaded with soils. [Pg.611]

In a pneumatic conveying system, air or some other gas is used to transfer solids from one place to another. These systems are entirely enclosed, hence the product loss is small, contamination is minimized, and the problem of dust emission to the atmosphere is greatly reduced. There are many different systems only a few will be presented here. [Pg.200]

The vast area of Arid and Semi-Arid ecosystems of Central and East Asia is subject to wind erosion. The major natural sources of dust emission are Gobi desert (Xinjiang... [Pg.170]

Figure 1. Annual dust emission rates in China (ton/ha/yr).

The annual dust emission rates for the whole China area are shown in Figure 1. [Pg.171]

We can see that due to joint effects of aridity and soil texture, the dust emission rates increase from east to west by as much as 5 orders. The maximum emission rate is 1.5 ton/ha/yr. The total dust emission amount of the Gobi desert is estimated as 25 x 106 tons per year and that in spring is 15 x 106 tons per year. The seasonal dust emission amounts in summer, autumn and winter are 1.4 x 106, 5.7 x 106 and 2.9 x 106 tons, correspondingly. [Pg.171]

Figure 19.10. Impact on reduction of fine dust emissions as a result of the introduction of hydrogen in road transport comparison of the high-support and fast-learning scenario with the baseline scenario scenario data are taken from Mattucci (2007).

An indication of the environmental effects of hydrogen deployment for each of six European countries (France, Germany, Italy, the Netherlands, Spain, and the UK) is given in Fig. 19.10, where the fine dust emissions are shown for the hydrogen high-penetration scenario. Similar trends are found for other pollutants. The data are normalised in respect to the baseline scenario and show a trend very similar for the analysed countries with a reduction of more than 70% in 2050. The results are an average per country. At a local level, higher reductions can also be achieved if nontechnical measures, such as limitation of city centre access for non-zero emission vehicles, are taken. [Pg.590]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...