Initiation kinetics

If p is taken to be a constant during a skid, application of Amontons law leads to a very simple relationship between the initial velocity of the vehicle and the length of the skid mark. The initial kinetic energy is mv fl, and this is to be entirely dissipated by the braking action, which amounts to a force F applied over the skid distance d. By Amontons law. [Pg.437]

Figure Bl.7.17. (a) Schematic diagram of a single acceleration zone time-of-flight mass spectrometer, (b) Schematic diagram showing the time focusing of ions with different initial velocities (and hence initial kinetic energies) onto the detector by the use of a reflecting ion mirror, (c) Wiley-McLaren type two stage acceleration zone time-of-flight mass spectrometer.

Classical ion trajectory computer simulations based on the BCA are a series of evaluations of two-body collisions. The parameters involved in each collision are tire type of atoms of the projectile and the target atom, the kinetic energy of the projectile and the impact parameter. The general procedure for implementation of such computer simulations is as follows. All of the parameters involved in tlie calculation are defined the surface structure in tenns of the types of the constituent atoms, their positions in the surface and their themial vibration amplitude the projectile in tenns of the type of ion to be used, the incident beam direction and the initial kinetic energy the detector in tenns of the position, size and detection efficiency the type of potential fiinctions for possible collision pairs. [Pg.1811]

Again, ion tunnels have no electric-field component in the z-direction, and ions must be injected with some initial kinetic energy if they are to pass through the device. [Pg.427]

Initializing the initial kinetic energy and temperature of the system it is necessary to start the motion at some level, eg, assume a Boltzmann (random) distribution of atomic velocities, at 300 K. [Pg.166]

Radiation Damage. It has been known for many years that bombardment of a crystal with energetic (keV to MeV) heavy ions produces regions of lattice disorder. An implanted ion entering a soHd with an initial kinetic energy of 100 keV comes to rest in the time scale of about 10 due to both electronic and nuclear coUisions. As an ion slows down and comes to rest in a crystal, it makes a number of coUisions with the lattice atoms. In these coUisions, sufficient energy may be transferred from the ion to displace an atom from its lattice site. Lattice atoms which are displaced by an incident ion are caUed primary knock-on atoms (PKA). A PKA can in turn displace other atoms, secondary knock-ons, etc. This process creates a cascade of atomic coUisions and is coUectively referred to as the coUision, or displacement, cascade. The disorder can be directiy observed by techniques sensitive to lattice stmcture, such as electron-transmission microscopy, MeV-particle channeling, and electron diffraction. [Pg.394]

The concentration of monomers in the aqueous phase is usually very low. This means that there is a greater chance that the initiator-derived radicals (I ) will undergo side reactions. Processes such as radical-radical reaction involving the initiator-derived and oligomeric species, primary radical termination, and transfer to initiator can be much more significant than in bulk, solution, or suspension polymerization and initiator efficiencies in emulsion polymerization are often very low. Initiation kinetics in emulsion polymerization are defined in terms of the entry coefficient (p) - a pseudo-first order rate coefficient for particle entry. [Pg.64]

The initial kinetic energy of 0 ions produced by dissociative attachment in 02 at an electron energy of 6.9 e.v. may be determined from Equation 4 to be 1.64 e.v. using values of 1.465 e.v. (1) for A(0) and 5.09 e.v. (7) for D(O—O). The residence time for 0 ions calculated from Equation 1 is 6.0 X 10 7 sec. at 10 volts repeller potential. Rate constants for Reaction 6 determined from data at varying Vr are shown in Table I and are seen to increase sharply with increasing repeller potential, as expected for an endothermic process. [Pg.41]

It Is well known that low values of Tq and [ ]q lead to high DPs. This Is accurately reflected by parameter (v )q, the Initial kinetic chain length (Table XIll), which Is a quotient of feed composition ratio Xq and dimensionless parameter a. Thus,... [Pg.32]

Figure 4. Operation of a plug-flow tubular addition polymerization reactor of fixed size using a specified free-radical initiator (initiator kinetic parameters Ea = 32,921 Kcal/mol In k/ = 26,492 In sec f = 0,5 10 ppm initiation, 1,0 mol %...

A more recent examination confirmed the existence of an unusual ionic-strength dependence of the reaction rate , which features a minimum at /r 0.83, but it was noted that the initial kinetics differ from those occurring later in the reaction. Consideration of the equilibria prevailing in aqueous solutions of Cr(VI) produced a simplified rate law... [Pg.281]

The regular availability of linear dependence between above values enabled us to substantiate two methods of detection the stationary and the kinetic one. The very names of these methods indicate that the first one makes it feasible to use the stationary values of adsorption-induced changes in electric conductivity of adsorbent to judge concentration of the particles detected. The second method enables one to obtain the same information using the measurements of initial kinetics of the change of electric conductivity. [Pg.163]

Chiral ligand 31 has two C-2 symmetrical picolynyl amides. Initial kinetics taught us the reaction was 0.5 order in 31. The kinetics indicated a dimeric nature of the active species. Therefore, systematic modification of the ligand was attempted and the results are summarized in Figure 2.5 [25]. [Pg.67]

To operate the ion TOF spectrometer in the velocity mode, we adapted a single-stage TOF spectrometer as shown in Fig. 3, which consisted of a repeller, an extractor (and guard rings, not shown) and a free-drift tube. After laser ionization, ions are extracted towards the MCP detector. For an ion with an initial kinetic energy Do, the total flight time t can be written as... [Pg.7]

Conditions of Coalescence. The outcome of the collision of two binder-covered particles is determined by the ratio of the initial kinetic energy of the system and the energy dissipated in the liquid bridge and in the particles. This can be expressed analytically by the definition of a so called Stokes number, St... [Pg.383]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...