Inversion symmetries

If a eenter of symmetry is present, all of the states arising from are gerade however, the states arising from 71% ean be gerade if n and 71 are both g or both u or ungerade if n and 71 are of opposite inversion symmetry. [Pg.264]

The C2H2CI2 molecule has a ah plane of symmetry (plane of molecule), a C2 axis ( to plane), and inversion symmetry, this results in C2h symmetry. Using C2h symmetry labels... [Pg.367]

It should be noted that, whereas ferroelectrics are necessarily piezoelectrics, the converse need not apply. The necessary condition for a crystal to be piezoelectric is that it must lack a centre of inversion symmetry. Of the 32 point groups, 20 qualify for piezoelectricity on this criterion, but for ferroelectric behaviour a further criterion is required (the possession of a single non-equivalent direction) and only 10 space groups meet this additional requirement. An example of a crystal that is piezoelectric but not ferroelectric is quartz, and ind this is a particularly important example since the use of quartz for oscillator stabilization has permitted the development of extremely accurate clocks (I in 10 ) and has also made possible the whole of modern radio and television broadcasting including mobile radio communications with aircraft and ground vehicles. [Pg.58]

Figure 16-10. Potential energy (per phenyl-phenyl bond) for rotation in the terphcnyl molecule1 shown ( R = H, R=OCHj, R=C2H5). The central ring was rotated and subsequently the geometry was fully optimized while retaining inversion symmetry for the molecule.

Recent observations of fluorescence in NpF6 and PuF6 (46) are consistent with the energy-level scheme proposed. However, comparison of the calculated level structure with high-resolution spectra of PuFg (44) confirms that much of the observed structure is vibronic in character, built on electronic transitions that are forbidden by the inversion symmetry at the Pu site. [Pg.197]

We start with some elementary information about anisotropic intermolec-ular interactions in liquid crystals and molecular factors that influence the smectic behaviour. The various types of molecular models and commonly accepted concepts reproducing the smectic behaviour are evaluated. Then we discuss in more detail the breaking of head-to-tail inversion symmetry in smectic layers formed by polar and (or) sterically asymmetric molecules and formation of particular phases with one and two dimensional periodicity. We then proceed with the description of the structure and phase behaviour of terminally fluorinated and polyphilic mesogens and specific polar properties of the achiral chevron structures. Finally, different possibilities for bridging the gap between smectic and columnar phases are considered. [Pg.200]

Moreover, the new smectic phases with the broken head-to-tail inversion symmetry (of the type of A, A2, A, etc.) and the re-entrant effects (i.e. the reentrance of the less ordered phase at temperatures below those of a more ordered phase) were found among strongly asymmetric mesogens [11-13, 30] (Fig. 2). These observations indicate that with asymmetric molecules, dipolar and steric interactions are important for the liquid crystalline behaviour. [Pg.205]

The symmetry properties of the pentacoordinate stereoisomerizations have been investigated on the Berry processes. They have been analyzed by defining two operators Q and The operator / is the geometrical inversion about the center of the trigonal bipyramid. Since this skeleton has no inversion symmetry, / moves the skeleton into another position. Moreover, if the five ligands are different, it transforms any isomer into its enantiomer, as shown in Fig. 3. [Pg.52]

D = dihedral (rotation plus dihedral rotation axes) I = inversion symmetry T = tetrahedral symmetry O = octahedral S5mimetry... [Pg.53]

In the Hermann-Mauguin Symbols, the same rotational axes are indicated, plus any inversion symmetry that may be present. The numbers indicate the number of rotations present, m shows that a mirror symmetry is present and the inversion symmetry is indicated by a bar over the number, i.e.- 0. [Pg.53]

Screw eixes are also common among crystals of the simpler organic compounds. But, many of these have mirror and inversion symmetry as well. The most common space groups for organic compounds are P 2i/c (26%), P 2i 2i 2i (13%), P 2i (8%), and C2/c (7%). [Pg.62]

Second-order NLO processes, including SFG, are strictly forbidden in media with inversion symmetry under the electric dipole approximation and are allowed only at the interface between these media where the inversion symmetry is necessarily broken. In the IR-Visible SFG measurement, a visible laser beam (covis) and a tunable infrared laser beam (cOir) are overlapped at an interface and the SFG signal is measured by scanning cOir while keeping cOvis constant. The SFG intensity (Isfg) is enhanced when coir becomes equal to the vibration levels of the molecules at the interface. Thus, one can obtain surface-specific vibrational spectra at an interface... [Pg.72]

It was believed for a long time that the fundamental laws of nature are invariant under space inversion, and hence the conservation of space inversion symmetry (P) is a universally accepted principle. The nonconservation of this symmetry was discovered experimentally by Wu and co-workers in the (3 decay of 60Co in... [Pg.239]

After the discovery of the combined charge and space symmetry violation, or CP violation, in the decay of neutral mesons [2], the search for the EDMs of elementary particles has become one of the fundamental problems in physics. A permanent EDM is induced by the super-weak interactions that violate both space inversion symmetry and time reversal invariance [11], Considerable experimental efforts have been invested in probing for atomic EDMs (da) induced by EDMs of the proton, neutron, and electron, and by the P,T-odd interactions between them. The best available limit for the electron EDM, de, was obtained from atomic T1 experiments [12], which established an upper limit of de < 1.6 x 10 27e-cm. The benchmark upper limit on a nuclear EDM is obtained from the atomic EDM experiment on Iyt,Hg [13] as d ig < 2.1 x 10 2 e-cm, from which the best restriction on the proton EDM, dp < 5.4 x 10 24e-cm, was also obtained by Dmitriev and Senkov [14]. The previous upper limit on the proton EDM was estimated from the molecular T1F experiments by Hinds and co-workers [15]. [Pg.241]

As mentioned earlier, heavy polar diatomic molecules, such as BaF, YbF, T1F, and PbO, are the prime experimental probes for the search of the violation of space inversion symmetry (P) and time reversal invariance (T). The experimental detection of these effects has important consequences [37, 38] for the theory of fundamental interactions or for physics beyond the standard model [39, 40]. For instance, a series of experiments on T1F [41] have already been reported, which provide the tightest limit available on the tensor coupling constant Cj, proton electric dipole moment (EDM) dp, and so on. Experiments on the YbF and BaF molecules are also of fundamental significance for the study of symmetry violation in nature, as these experiments have the potential to detect effects due to the electron EDM de. Accurate theoretical calculations are also absolutely necessary to interpret these ongoing (and perhaps forthcoming) experimental outcomes. For example, knowledge of the effective electric field E (characterized by Wd) on the unpaired electron is required to link the experimentally determined P,T-odd frequency shift with the electron s EDM de in the ground (X2X /2) state of YbF and BaF. [Pg.253]

Solvent properties, transition state trajectory, future research issues, 232-233 Space inversion symmetry (P) ab initio calculations, 253—259 barium fluroide molecules, 256-259 ytterbium molecule, 254—256 electric dipole moment search, 241-242 nonconservation, 239—241 Spatial neighbor tables, Monte Carlo heat flow simulation, 68—70... [Pg.287]

See also in sourсe #XX -- [ Pg.50 ]

See also in sourсe #XX -- [ Pg.254 ]

See also in sourсe #XX -- [ Pg.64 , Pg.419 , Pg.420 ]

See also in sourсe #XX -- [ Pg.53 , Pg.54 ]

See also in sourсe #XX -- [ Pg.22 ]

See also in sourсe #XX -- [ Pg.53 , Pg.58 ]

See also in sourсe #XX -- [ Pg.2 , Pg.2 , Pg.3 , Pg.3 , Pg.3 , Pg.3 ]

See also in sourсe #XX -- [ Pg.173 ]

See also in sourсe #XX -- [ Pg.157 ]

See also in sourсe #XX -- [ Pg.346 ]

See also in sourсe #XX -- [ Pg.247 ]

See also in sourсe #XX -- [ Pg.9 ]

See also in sourсe #XX -- [ Pg.22 , Pg.37 ]

See also in sourсe #XX -- [ Pg.872 ]

See also in sourсe #XX -- [ Pg.143 ]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...