Macroscopic level

The van der Waals forces on the molecular level can be easily extended to the macroscopic level applied for the colloidal particles case, through integrating the attractive energy shown above over the total number of molecules in the area considered. The attractive energy between two identical blocks (same thickness and surface area) can be expressed as [151 [Pg.241]

For two identical spheres with narrow separation distance, r d, Eq.(22) can be simplified as [Pg.242]

Note the difference between Hq.(20) and (25). The attraction van der Waals force between macroscopic bodies is clearly dependent on the geometries of two units. [Pg.242]

Principally two techniques are used to measure the second-order nonlinear optical susceptibilities. These are [Pg.9]

This example illustrates how the Onsager theory may be applied at the macroscopic level in a self-consistent maimer. The ingredients are the averaged regression equations and the entropy. Together, these quantities pennit the calculation of the fluctuating force correlation matrix, Q. Diffusion is used here to illustrate the procedure in detail because diffiision is the simplest known case exlribiting continuous variables. [Pg.705]

Although a system at equilibrium appears static on a macroscopic level, it is important to remember that the forward and reverse reactions still occur. A reaction at equilibrium exists in a steady state, in which the rate at which any species forms equals the rate at which it is consumed. [Pg.136]

The essential information implied by the chemical equation is the stoichiometry at the macroscopic level, ie, if a moles of M react, then b moles of B do also p moles of P are formed, etc. No inference should be made about behavior at the microscopic or atomic level, ie, there is no implication thatp molecules of P appear simultaneously. There may or may not be intermediates that appear and disappear in the course of the reaction. [Pg.507]

Values of Go were within a factor of 2 of the expected W while v varied from 5 to 215 nm s in their acrylic elastomeric system. Experiments conducted by Luengo et al. [119] suggest the existence of at least two different dissipation processes one at the molecular level and the other at the microscopic to macroscopic level. [Pg.129]

Kinetic theories of adsorption, desorption, surface diffusion, and surface reactions can be grouped into three categories. (/) At the macroscopic level one proceeds to write down kinetic equations for macroscopic variables, in particular rate equations for the (local) coverage or for partial coverages. This can be done in a heuristic manner, much akin to procedures in gas-phase kinetics or, in a rigorous approach, using the framework of nonequihbrium thermodynamics. Such an approach can be used as long as... [Pg.439]

Thus, there are rather many microscopic processes which contribute to result in hydrogen-improved workability. To elucidate all contributions to this beneficial phenomenon, further study of the plastic flow of titanium alloys is necessary both at microscopic and macroscopic levels. [Pg.436]

Using the latter as a unit of speed, one finds that c = l/ /2, and is independent of direction and density of the LG [salem86j. The HPP LG thus also furnishes us with our first example of a purely mechanical property that emerges only on the macroscopic level. [Pg.492]

Fig. 12.12. A circularly symmetric Gaussian probability distribution p x,y) describing a two-dimensional random walk emerges for large times on the macroscopic level, despite the fact that the underlying Euclidean lattice is anisotropic.

In spite of the presence of ECC, the sample exhibiting a domain structure remains unoriented on the macroscopic level. Figure 3 c shows a great difference in the structures obtained, if molecular orientation exists and if hydrostatic compression is applied. Although the method of hydrostatic compression of the melt is of paramount importance from the scientific view point just for samples crystallized under pressure it was possible to prove unequivocally the existence of ECC), it does not allow a direct preparation of oriented samples of high strength (they are brittle and readily crumble to powder under minimum strain). However, the material obtained in this way can probably serve as a semi-finished product for further technological treatment that would improve its mechanical properties. [Pg.217]

Even when they have a partial crystallinity, conducting polymers swell and shrink, changing their volume in a reverse way during redox processes a relaxation of the polymeric structure has to occur, decreasing the crystallinity to zero percent after a new cycle. In the literature, different relaxation theories (Table 7) have been developed that include structural aspects at the molecular level magnetic or mechanical properties of the constituent materials at the macroscopic level or the depolarization currents of the materials. [Pg.373]

A sense of scale is important for understanding how chemistry at the macroscopic level is related to the behavior of atoms at the microscopic level. Atoms are extraordinarily small, and there are vast numbers in even very tiny objects. The diameter of a carbon atom is only about 150 trillionths of a meter, and we would have to put 10 million atoms side by side to span the length of this dash -. Even a small cup of coffee contains more water molecules than there are stars in the visible universe. [Pg.26]

Why Do We Need to Know Ihis Material Chemical kinetics provides us with tools that we can use to study the rates of chemical reactions on both the macroscopic and the atomic levels. At the atomic level, chemical kinetics is a source of insight into the nature and mechanisms of chemical reactions. At the macroscopic level, information from chemical kinetics allows us to model complex systems, such as the processes taking place in the human body and the atmosphere. The development of catalysts, which are substances that speed up chemical reactions, is a branch of chemical kinetics crucial to the chemical industry, to the solution of major problems such as world hunger, and to the development of new fuels. [Pg.649]

Ben-Zvi, Eylon, Silberstein, 1987) macroscopic level microscopic level symbolic level... [Pg.6]

To elucidate the distinction between the sub-microscopic and macroscopic worlds, Table 1.1 lists some observable chemical phenomena (the macroscopic level) along with the corresponding explanatory models that we use at the sub-microscropic level. [Pg.13]

Table 1.2 Aspects of dioxygen gas at the molar, molecular and electrical (intramolecular) levels of discourse. Taken from Jensen (1998b). (Jensen s use of the term molar level eorresponds with the more common macroscopic level.)...

At the macroscopic level, students can also be shown a piece of iron disappearing in dilute hydrochloric acid and asked to comment on the statement that... [Pg.144]

Once the concept of solubility is understood, students look at animations that show two solutions being mixed resulting in the exchange of ions and formation of an insoluble compound (see the screen captures in Figs. 6.2, 6.3 and 6.4). Students generally do not consider how precipitates are formed, so the animation showing how the ions (at the sub-microscopic level) attract each other and aggregate to form a precipitate (at the macroscopic level) will help them to understand the interactions of the ions involved. [Pg.145]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...