Membranes cost effects

PI types that are built from 2,4,6-trimethyl-1,3-phenylenediamine and 3,3, 4,4 -benzophenone tetracarboxylic dianhydride are photochemically crosslinkable due to the benzophenone incorporated. It is essential that pendent alkyl groups are attached to the aromatic structure. " However, it has been objected that photochemical crosslinking is not a practical method for fabricating gas separation membranes cost-effectively. ... [Pg.494]

Although considerable research has been conducted with Pd-alloy foils, tubes, and thinner composite membranes, long-term durability and stability need to be further demonstrated, especially in the fuel reforming or WGS operating conditions, for acceptance of this technology in a commercial sector. Furthermore, mass-scale and cost-effective production of industrial-scale Pd-alloy thin-film composite membranes need to be demonstrated to be competitive in the hydrogen production and purification market. [Pg.305]

Up until more recent history, most of the separators and membranes historically used had not been specifically developed for battery applications. Thus, future research should be aimed at developing separators that are specifically tailored for battery applications. The general objectives of separator research should be as follows (a) to find new and cost-effective separators, (b) to understand the separator properties in batteries, and (c) to optimize separator properties related to specific cell performance, life. [Pg.219]

It should be obvious from the above that fluid-management techniques which Improve the mass-transfer coefficient (k) with minimum power consumption are most desirable. However, in some cases, low-cost membrane configurations with inefficient fluid management may be more cost effective. In any case, it is important to understand quantitatively how tangential velocity and mem-brane/hardware geometry affects the mass-transfer coefficient. [Pg.414]

More than 800 million pounds of EPM and EPDM polymers were produced in the United States in 2001. Their volume ranks these materials fourth behind styrene-1,3-butadiene copolymers, poly( 1,4-butadiene), and butyl rubber as synthetic rubbers. EPM and EPDM polymers have good chemical resistance, especially toward ozone. They are very cost-effective products since physical properties are retained when blended with large amounts of fillers and oil. Applications include automobile radiator hose, weather stripping, and roofing membrane. [Pg.698]

The filter material of choice is a thin teflon membrane since it minimizes artifact formation and maximizes analytical sensitivity by X-ray fluorescence analysis. Although X-ray fluorescence (XRF) may not be the only analytical technique used, it is generally accepted as being the most cost effective analysis for source apportionment. ( 2) Its background and therefore, analytical sensitivity, is dependent on the filters surface density. The analytical sensitivity of XRF for aerosols deposited on a stretched teflon membrane with a density of about 0.3 to 0.4 mg/cm, for example, is about three times greater than an aerosol deposited on a cellulose based filter with a surface density of about 4 mg/cm. This difference can be translated into either more information for the same analytical costs or the same information for a lower analysis cost. [Pg.84]

The smaller oxygen molecules, therefore, would pass through the membrane more readily. In fact, such membranes exist, and they are being developed as a cost-effective means of separating atmospheric nitrogen from oxygen, as shown in Figure 5.27. [Pg.169]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...