Other Ions

As with the quadmpole ion trap, ions with a particular m/z ratio can be selected and stored in tlie FT-ICR cell by the resonant ejection of all other ions. Once isolated, the ions can be stored for variable periods of time (even hours) and allowed to react with neutral reagents that are introduced into the trapping cell. In this maimer, the products of bi-molecular reactions can be monitored and, if done as a fiinction of trapping time, it is possible to derive rate constants for the reactions [47]. Collision-induced dissociation can also be perfomied in the FT-ICR cell by tlie isolation and subsequent excitation of the cyclotron frequency of the ions. The extra translational kinetic energy of the ion packet results in energetic collisions between the ions and background... [Pg.1357]

Taking francium as an example, it was assumed that the minute traces of francium ion Fr could be separated from other ions in solution by co-precipitation with insoluble caesium chlorate (VII) (perchlorate) because francium lies next to caesium in Group lA. This assumption proved to be correct and francium was separated by this method. Similarly, separation of astatine as the astatide ion At was achieved by co-precipitation on silver iodide because silver astatide AgAt was also expected to be insoluble. [Pg.22]

The ability of living organisms to differentiate between the chemically similar sodium and potassium ions must depend upon some difference between these two ions in aqueous solution. Essentially, this difference is one of size of the hydrated ions, which in turn means a difference in the force of electrostatic (coulombic) attraction between the hydrated cation and a negatively-charged site in the cell membrane thus a site may be able to accept the smaller ion Na (aq) and reject the larger K (aq). This same mechanism of selectivity operates in other ion-selection processes, notably in ion-exchange resins. [Pg.124]

The small lithium Li" and beryllium Be ions have high charge-radius ratios and consequently exert particularly strong attractions on other ions and on polar molecules. These attractions result in both high lattice and hydration energies and it is these high energies which account for many of the abnormal properties of the ionic compounds of lithium and beryllium. [Pg.134]

Conversion of the salt of a weak base into the free base. Prepare a column of a strong base anion resin (such as Amberlite IRA-40o(OH) ) washed with distilled water as above. Drain off most of the water and then allow 100 ml. of A//2.Na.2C03 solution to pass through the column at 5 ml. per minute. Again wash the column with 200 ml. of distilled water. Dissolve 0-05 g. of aniline hydrochloride in 100 ml. of distilled water and pass the solution down the column. The effluent contains aniline in solution and free from all other ions. [Pg.57]

The results of electrostatic potential calculations can be used to predict initial attack positions of protons (or other ions) during a reaction. You can use the Contour Plot dialog box to request a plot of the contour map of the electrostatic potential of a molecular system after you done a semi-empirical or ab initio calculation. By definition, the electrostatic potential is calculated using the following expression ... [Pg.244]

Ion-exchange methods are based essentially on a reversible exchange of ions between an external liquid phase and an ionic solid phase. The solid phase consists of a polymeric matrix, insoluble, but permeable, which contains fixed charge groups and mobile counter ions of opposite charge. These counter ions can be exchanged for other ions in the external liquid phase. Enrichment of one or several of the components is obtained if selective exchange forces are operative. The method is limited to substances at least partially in ionized form. [Pg.1109]

Precipitate particles grow in size because of the electrostatic attraction between charged ions on the surface of the precipitate and oppositely charged ions in solution. Ions common to the precipitate are chemically adsorbed, extending the crystal lattice. Other ions may be physically adsorbed and, unless displaced, are incorporated into the crystal lattice as a coprecipitated impurity. Physically adsorbed ions are less strongly attracted to the surface and can be displaced by chemically adsorbed ions. [Pg.238]

Alternatively, ions of any one selected m/z value can be chosen by holding the magnetic field steady at the correct strength required to pass only the desired ions any other ions are lost to the walls of the instrument. The selected ions pass through the gas cell and are detected in the singlepoint ion collector. If there is a pressure of a neutral gas such as argon or helium in the gas cell, then ion-molecule collisions occur, with decomposition of some of the selected incident ions. This is the MS/MS mode. However, without the orthogonal TOF section, since there is no further separation by m/z value, the new ions produced in the gas cell would not be separated into individual m/z values before they reached the detector. Before the MS/MS mode can be used, the instrument must be operated in its hybrid state, as discussed below. [Pg.159]

In the transverse direction of the quadrupoles, an ion will oscillate among the poles in a complex fashion, depending on its mass, the voltages (U, V), and the frequency (to) of the alternating RF potential. By suitable choices of U, V, and to, it can be arranged that only ions of one mass will oscillate stably about the central axis in this case, all other ions will oscillate... [Pg.183]

Thus, ions are produced, deflected in a magnetic field, then focused in an electric field, and finally detected by an electron multiplier or other ion detector. [Pg.402]

Weak base resins when in the free base (hydroxyl) form are not capable of splitting neutral salts such as sodium chloride. Salt forms of weak base resins release anions to the Hquid phase if other ions for which the resin has a greater selectivity are present. [Pg.372]

Other Methods. Ion chromatography using conductance detection can be used to measure low (<1%) levels of nitrite, chloride, sulfate, and other ions in nitric acid. Techniques for ion chromatographic analysis are available (93). [Pg.47]

The surface of activated alumina is a complex mixture of aluminum, oxygen, and hydroxyl ions which combine in specific ways to produce both acid and base sites. These sites are the cause of surface activity and so are important in adsorption, chromatographic, and catalytic appHcations. Models have been developed to help explain the evolution of these sites on activation (19). Other ions present on the surface can alter the surface chemistry and this approach is commonly used to manipulate properties for various appHcations. [Pg.155]

Values quoted are ion (m/2) followed by relative abundance in parentheses. After m/2 109 and 80, the other ions may vary in abundance order dependent upon conditions employed (10). [Pg.308]

Polymerization and depolymerization of sihcate anions and their interactions with other ions and complexing agents are of great interest in sol—gel and catalyst manufacture, detergency, oil and gas production, waste management, and limnology (45—50). The complex silanol condensation process may be represented empirically by... [Pg.6]

Preferential flow through root-mediated soil pores has been demonstrated for chloride, nitrate, and other ions that are not sorbed onto soil organic matter and clays. However, pesticide sorption onto soil affects both mobiUty of the pesticide as well as its residual life in the soil. Pesticide sorption onto root organic matter or organic linings of worm burrows may also slow transport of pesticides relative to water (72), thus countering the effects of increased permeabihty caused by roots. [Pg.223]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...