Particulate matter Finely divided solid

Particulate matter Finely divided solid particles suspended in polluted air. [Pg.967]

Roll pressing of particulate matter is traditionally of greatest interest for all industries in which large quantities of finely divided solids, both valuable and worthless (wastes), must be handled. Originally developed as an economic... [Pg.260]

Particulates. A general term used to describe a finely divided solid of organic or inorganic matter. These solids are usually reported as contaminants by the population of a specific micrometer size. See ASTM F-312, Method for Microscopical Sizing and Counting Particles from Aerospace Fluids on Membrane Filters [4]. [Pg.199]

In recapping, DAF is the process of removing suspended solids, oils and other contaminants via the use of bubble flotation. Air is dissolved into the water, then mixed with the wastestream and released from solution while in intimate contact with the contaminants. Air bubbles form, saturated with air, mix with the wastewater influent and are injected into the DAF separation chamber. The dissolved air then comes out of solution, producing literally millions of microscopic bubbles. These bubbles attach themselves to the particulate matter and float then to the surface where they are mechanically skimmed and removed from the tank. Most systems are versatile enough to remove not only finely divided suspended solids, but fats, oils and grease (FOG). Typical wastes handled include various suspended... [Pg.319]

The simplest method of decomposing an organic sample prior to determining the cations it contains is to heat the sample over a flame in an open dish or crucible until all carbonaceous material has been oxidized to carbon dioxide. Red heat is often required to complete the oxidation. Analysis of the nonvolatile components follows dissolution of the residual solid. Unfortunately, there is always substantial uncertainty about the completeness of recovery of supposedly nonvolatile elements from a dry-ashed sample. Some losses probably result fiom the entrainment of finely divided particulate matter in the convection currents around the crucible. In addition, volatile metallic compounds may be lost during the ignition. For example, copper, iron, and vanadium are appreciably volatilized when samples containing porphyrin compounds are ashed. [Pg.1047]

The type of movement required for mixing particulate matter also produces ideal conditions for agglomeration by coalescence. Therefore, unwanted agglomeration is often observed in powder mixers, especially if the particle size of the solids is small and/or a small amount of moisture is present. Considerable problems can arise if components of the bulk mass have different particle sizes because, in that case, the smaller fractions may selectively agglomerate, thus making it impossible to obtain an ideal mixture. Such selective agglomeration is of particular concern in the pharmaceutical industry where an extremely small amount of a finely divided active substance must often be mixed uniformly and reliably with a relatively large amount of inert filler material. [Pg.178]

Finally, particulate matter (PM), or the solid and liquid particles that are released into the atmosphere, comes from both the actual emissions of particulates and the reaction between atmospheric molecules and SO2 or NO. Particulate matter can be divided based on the size of the particle. Health effects include respiratory distress as well as cancer and permanent lung damage. Fine particulate matter (<2.5 microns in size, PM 2.5) is a major cause of reduced visibility, or haze, in many parts of the country. The EPA notes visibility in several of our nation s national parks and wilderness areas has been negatively affected by high particulate levels in the air. Particulate emissions that are not the result of other pollutants or natural causes come primarily from the industrial sector (EPA 1995). [Pg.112]

Smoke is produced by burning hydrocarbons and solids in considerable quantities, (particularly under conditions of incomplete combustion). It is also produced in large quantities by burning electrical and electronic equipment. Smoke consists of finely divided particulate matter and suspended liquid droplets (aerosols) and can contain toxic byproducts of combustion. Smoke creates a serious hazard to personnel due to its physiological effects and the reduction of visibility (most of the deaths on the Piper Alpha platform were of men in their living quarters who were overcome by smoke). [Pg.300]

Diesel particulate matter (PM) is a complex multi-phase multi-component material, which is traditionally and conveniently divided into three main fractions a solid fraction mainly comprising carbon particles and ash, a soluble organic fraction where the m ority of the hydrocarbons originating from the lube oil and fuel are concentrated, and sulfate particulates derived from the sulfur content of the fuel. The sizes of particulate matter from diesel engines are characterized by a distribution spread (Fig. 11.1) PMIO (diameter less than 10 pm), fine particles (less than 2.5 pm), ultrafine particles (less than 0.1 pm) and nanoparticles (less than 50 nm). ... [Pg.566]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...