Second-order reactions homogeneous

Ion-exchange processes are strictly heterogeneous reactions that involve two phases. They, however, mostly comply with homogeneous, second-order reaction kinetics. An exchange reaction represented by... [Pg.503]

The slow, thermal decomposition of hydrazoic acid in a static system has been studied by Meyer and Schumacher58. It turned out to be completely governed by heterogeneous catalysis. There are no studies on the kinetics of the homogeneous decomposition of this substance save for the investigation of its decomposition flame59. From the variation of flame properties with pressure it can be deduced that second-order reactions control the over-all rate. The unimolecular reaction... [Pg.26]

The preceding approach applies to all linear systems that is, those involving mechanisms in which only first-order or pseudo-first-order homogeneous reactions are coupled with the heterogeneous electron transfer steps. As seen, for example, in Section 2.2.5, it also applies to higher-order systems, involving second-order reactions, when they obey pure kinetic conditions (i.e., when the kinetic dimensionless parameters are large). If this is not the case, nonlinear partial derivative equations of the type... [Pg.123]

More complicated reactions that combine competition between first- and second-order reactions with ECE-DISP processes are treated in detail in Section 6.2.8. The results of these theoretical treatments are used to analyze the mechanism of carbon dioxide reduction (Section 2.5.4) and the question of Fl-atom transfer vs. electron + proton transfer (Section 2.5.5). A treatment very similar to the latter case has also been used to treat the preparative-scale results in electrochemically triggered SrnI substitution reactions (Section 2.5.6). From this large range of treated reaction schemes and experimental illustrations, one may address with little adaptation any type of reaction scheme that associates electrode electron transfers and homogeneous reactions. [Pg.139]

Most electrode reactions of interest to the organic electrochemist involve chemical reaction steps. These are often assumed to occur in a homogeneous solution, that is, not at the electrode surface itself. They are described by the usual chemical kinetic equations, for example, first- or second-order reactions and may be reversible (chemical reversibility) or irreversible. [Pg.5]

For bimolecular second-order reactions and for trimolecular reactions, if the reaction rate is very high compared to the rate to bring particles together by diffusion (for gas-phase and liquid-phase reactions), or if diffusion is slow compared to the reaction rate (for homogenous reaction in a glass or mineral), or if the concentrations of the reactants are very low, then the reaction may be limited by diffusion, and is called an encounter-controlled reaction. [Pg.32]

What factors afiect the rate of homogeneous and heterogeneous chemical reactions What is called the order of a reaction Give-examples of first- and second-order reactions. Write a mathematical expression of the law of mass action for a first- and second-order irreversible reactions. [Pg.73]

Sterically demanding benzilic acid was used to optimize the reaction conditions in respect to reagent excess and reaction time. Complete conversion (98%) of benzilic acid to the corresponding methyl ester was obtained with two equivalents of the methyl triazene resin 10 after 6 h 96% conversion was obtained when using the n-butyl triazene resin 10. The reaction between p-nitrophenylacetic acid (1 equiv., 2 mg/ml) and the polymer-supported triazene (2 equiv.) in DCM was monitored by HPLC. A 53% conversion from the acid to the ester product was observed after 5 min data analysis indicated a second-order reaction as observed in homogeneous solution. [Pg.381]

The constants for these second order reactions have been determined and they indicate that the first reaction proceeds at a considerably faster rate than the second reaction. It is possible that the van den Bergh reaction, as used in clinical chemistry, takes place in the same way but, as it is not taking place in a homogeneous medium, it is probable that the kinetics will be more complicated. [Pg.270]

In an EC2j process, the initial ET step is followed by a second-order irreversible homogeneous reaction. For example, the feedback mode of SECM was employed to study the reductive hydrodimerization of the dimethyl fumarate (DF) radical anion [22]. The experiments were carried out in solutions containing either 5.15 or 11.5 mM DF and 0.1 M tetrabutylammonium tetrafluoroborate in A,A,-dimethyl form amide (DMF). The increase in the feedback current with increasing concentration of DF indicated that the homogeneous step involved in this process is not a first-order reaction. The analysis of the data based on the EC2 theory yielded the fc2 values of 180M-1 s-1 and 160M-1 s-1 for two different concentrations. Another second order reaction studied by the TG/SC mode was oxidative dimerization of 4-nitrophenolate (ArO-) in acetonitrile [23]. In this experiment, the tip was placed at a fixed distance from the substrate. The d value was determined from the positive feedback current of benzoquinone, which did not interfere with the reaction of interest. The dimerization rate constant of (1.2 0.3) x 108 M x s-1 was obtained for different concentrations of ArO-. [Pg.231]

Fig. 13. Comparison of conversion for a bimolecular second-order reaction in a homogeneous tubular reactor for premixed and unmixed reactant feeding.

Rate constants for homogeneous reactions of tip-generated species as they transit between tip and conducting substrate can be determined from steady-state feedback current or TG/SC experiments or by transient measurements (Chapter 7). Generally rate constants can be measured if the lifetime of the species of interest is of the order of the diffusion time between tip and substrate, d2HD. Thus first-order reaction rate constants up to about 105 s and second-order reaction rate constants up to about 10s M 1 s are accessible. [Pg.10]

The dimerization of butadiene in the gas phase is a homogeneous second-order reaction (see problem 142). Values of the second-order rate constant at several temperatures (Kistiakowsky and Ransom, J. Chem. Phys. 1939, 7, 725) are given in table 1, where is defined by... [Pg.407]

The modification of cellulose with alkaline carbon disulfide to introduce xanthate groups has been extensively exploited in the industrial production of viscose. Early work on the preparation and properties of starch xanthate has been discussed. Xanthate derivatives of cellulose and starch have been discussed with respect to general xanthate chemistry, and the xanthation of cellulose in homogeneous medium is known to be a second-order reaction. Cellulose xanthate shows some potential as a matrix for enzyme insolubilization, " and stable derivatives of this xanthate may be prepared by transesterification. Thermal decomposition of cellulose allyl- and benzyl-xanthates gives 5,6-cellulosene. Some thiocarbonyl derivatives of polysaccharides have been prepared. "... [Pg.346]

Examples of such consecutive competing reactions are chlorination, nitration of hydrocarbons, or the addition of alkene oxides (e.g., ethylene oxide) to amines or alcohols. If the mixing is fast enough, so that the reacting fluid is homogenous before the reaction takes place, the maximum yield of the desired intermediate A3 will be controlled by the ratio of k2/ky Let us suppose irreversible second order reactions, so the following relations describe the transformation rates of the involved reactants. [Pg.133]

In general, first- and second-order reactions are most commonly seen, but reactions of other orders are also important. Direct analytical solutions are easily acquired for zero-order, first-order, and second-order reactions. Reactions of third-order or higher generally require numerical methods for solution. In the sections that follow, we will cover several examples of zero-order, first-order, and second-order homogeneous chemical reactions. [Pg.51]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...