Sodium hydroxide reaction with hydrogen

When acids and bases come into contact with one another, a chemical reaction called a neutralization reaction takes place. A neutralization reaction is a double displacement reaction. In a double displacement reaction, the positive ions from one reactant take the place of the positive ions in the other reactant. For example, if hydrochloric acid and sodium hydroxide react with one another, the positive sodium ion in sodium hydroxide will take the place of the hydrogen ion in the hydrochloric acid ... [Pg.44]

The epoxy resin component is made by a 2-stage process involving reaction of l-chloro-2,3-epoxypropane (epichlorhydrin) with isocyanuric acid to give the l,3,5-tris(2-hydroxy-3-chloropropyl) derivative, which is then treated with sodium hydroxide to eliminate hydrogen chloride to form the title compound. One batch contained more than the normal amount of hydroly sable chlorine, and when excess epichlorhydrin was distilled off, the residual material decomposed with explosive violence. It was later established that the abnormal chlorine content was associated with reduced thermal stability, and criteria for hydrolysable chlorine, epoxy content and pH have been set to prevent distillation of off-spec, material. [Pg.1167]

To a flask containing 250 ml (2.74 moles) of n-butanol is added 37.8 gm (0.3 mole) of V,.V-diisopropylcyanamide. Dry hydrogen chloride gas is slowly added, while the temperature is kept at 25°C, to saturate the reaction mixture (1.0-1.1 equivalents of hydrogen chloride are satisfactory) [41]. After standing for 1-15 days the mixture is made alkaline with sodium hydroxide, extracted with benzene, and distilled to afford 23.3 gm (39 %), b.p. 62°C (0.2 mm), n 1.4491, dj5 0.9005. [Pg.97]

Dissolve several crystals of the obtained salt in a small amount of water. Pour the solution into two test tubes, add 1-2 ml of a sodium hydroxide solution to one of them and hydrogen sulphide water to the other. What is observed How can you explain the different reaction of the sodium hydroxide solution and hydrogen sulphide with the solution of the obtained salt ... [Pg.253]

Heating 4- and 5-bromoacyl silanes at 100 °C in a polar aprotic solvent induces cyclization through the enol forms to give 2-silyldihydrofurans and 2-silyldihydropyrans, respectively195. Similar transformation of 4- to 7-halothioacyl silanes, prepared from the corresponding haloacyl silanes by reaction with hydrogen sulphide, but induced by sodium hydroxide, gave the 2-silylated sulphur heterocycles in excellent yields (Scheme 84)196. Intermolecular enolate reactions of acyl silanes are also known (vide infra, Section IV.A.6). [Pg.1644]

Cognate preparation. m-Nitrobenzyl alcohol. Clamp a 500-ml three-necked flask, equipped with a mechanical stirrer, a thermometer and a burette, above the bench so that an ice bath can be placed beneath it. Place a solution of 15.1 g (0.1 mol) of m-nitrobenzaldehyde (Expt 6.19) in 100 ml of methanol in the flask and, while stirring, add a solution of sodium borohydride (1.4g, 0.037 mol NaBH4 in 2 ml of 2 m sodium hydroxide diluted with 18 ml of water) at the rate of 0.5 ml per minute, with occasional cooling to keep the reaction at 18-25 °C. When about three-quarters of the solution has been added, there is no further tendency for the temperature to rise, and the addition is stopped. Treat a small portion of the reaction mixture with dilute sulphuric acid hydrogen should be evolved. [Pg.524]

In a 250 ml three-necked flask was placed (dichloroiodo)benzene (7.25 g, 30 mmol) with light protection, under nitrogen. Then 2,3-dimethylbutane (30.25 g, 350 mmol) and trihexylborane (400 mg, 1.5 mmol) were introduced by syringes through a septum inlet. The mixture was stirred at room temperature for about 2 h during the reaction hydrogen chloride evolved was carried into an aqueous sodium hydroxide solution by a weak stream of nitrogen. The reaction mixture was neutralized with dilute sodium hydroxide, washed with water several times and dried. Fractional distillation afforded 2-chloro-2,3-dimethylbutane (3.22 g, 89%), b.p. 109-110°C. [Pg.100]

Hence, about 1.5 moles of Na2S is needed for each nitro group to be reduced. (The reduction does not always follow exactly the reaction given. Hence, the optimum quantity of sodium sulfide may vary somewhat from the theoretical amount and must be determined by trial.) Frequency, the hydroxide formed in the reaction has a deleterious effect, and in this event better results are obtained with sodium hydrosulfide (NaSH), i.e., a solution of sodium sulfide saturated with hydrogen sulfide. The reaction then proceeds without forming hydroxide, according to the equation ... [Pg.72]

Bulk aluminum may undergo the following dangerous interactions exothermic reaction with butanol, methanol, 2-propanol, or other alcohols, sodium hydroxide to release explosive hydrogen gas. Reaction with diborane forms pyrophoric product. Ignition on contact with niobium oxide + sulfur. Explosive reaction with molten metal oxides, oxosalts (nitrates, sulfates), sulfides, and sodium carbonate. Reaction with arsenic trioxide + sodium arsenate + sodium hydroxide produces the toxic arsine gas. Violent reaction with chlorine trifluoride, Incandescent reaction with formic acid. Potentially violent alloy formation with palladium, platinum at mp of Al, 600°C. Vigorous dissolution reaction in... [Pg.44]

SAFETY PROFILE Confirmed carcinogen. Moderately toxic by ingestion. Mutation data reported. Explosive reaction with sodium hydroxide + zinc. Vigorous reaction with hydrogen + catalyst (at 250°C/34bar). When heated to decomposition it emits toxic fumes of NOx. See also p-NITROANISOLE. [Pg.1006]

Experiment 201. — Mix 5 cc. each of zinc sulphate and alum (common) solutions. Precipitate and redissolve the hydroxides of zinc and aluminium with sodium hydroxide solution. Pass hydrogen sulphide gas into the solution, or add considerable hydrogen sulphide water. Filter. The precipitate is zinc sulphide, which may be further tested, if desired, though the formation of zinc sulphide under these conditions indicates the presence of zinc. The aluminium is in the filtrate as sodium aluminate. Add to the solution of sodium aluminate hydrochloric acid to acid reaction, and boil filter, if necessary, and test the filtrate for aluminium. [Pg.325]

Hydration of attenic nitriles. 4,4-Dialkyl-substitutcd allenic nitriles (1) are converted into allenic amides (2) in 60 70% yield by reaction with hydrogen peroxide in alcoholic sodium hydroxide. [Pg.255]

Regarding the well-known disappearance of lithium or sodium in reaction with water, it must be demonstrated that the gas hydrogen is formed and new white substances - hydroxides of the metals, appear after the water has been evaporated from the alkaline solutions (see E3.7). So the metals are reacting... [Pg.45]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...