Analysis titrimetric

The accuracy of a standardization depends on the quality of the reagents and glassware used to prepare standards. For example, in an acid-base titration, the amount of analyte is related to the absolute amount of titrant used in the analysis by the stoichiometry of the chemical reaction between the analyte and the titrant. The amount of titrant used is the product of the signal (which is the volume of titrant) and the titrant s concentration. Thus, the accuracy of a titrimetric analysis can be no better than the accuracy to which the titrant s concentration is known. [Pg.106]

Titrimetric analysis is a classical method for generating concentration-time data, especially in second-order reactions. We illustrate with data on the acetylation of isopropanol (reactant B) by acetic anhydride (reactant A), catalyzed by A-methyl-imidazole. The kinetics were followed by hydrolyzing 5.0-ml samples at known times and titrating with standard base. A blank is carried out with the reagents but no alcohol. The reaction is... [Pg.32]

The method of evaluation of the rate constants for this reaction scheme will depend upon the type of analytical information available. This depends in part upon the nature of the reaction, but it also depends upon the contemporary state of analytical chemistry. Up to the middle of the 20th century, titrimetry was a widely applied means of studying reaction kinetics. Titrimetric analysis is not highly sensitive, nor is it very selective, but it is accurate and has the considerable advantage of providing absolute concentrations. When used to study the A —> B — C system in which the same substance is either produced or consumed in each step (e.g., the hydrolysis of a diamide or a diester), titration results yield a quantity F = Cb + 2cc- Swain devised a technique, called the time-ratio method, to evaluate the rate... [Pg.69]

The aqueous solution chemistiy of nitrous acid and nitrites has been extensively studied. Some reduction potentials involving these species are given in Table 11.4 (p. 434) and these form a useful summaiy of their redox reactions. Nitrites are quantitatively oxidized to nitrate by permanganate and this reaction is used in titrimetric analysis. Nitrites (and HNO2) are readily reduced to NO and N2O with SO2, to H2N2O2 with Sn(II), and to NH3 with H2S. Hydrazinium salts yield azides (p. 432) which can then react with further HNO2 ... [Pg.462]

In titrimetric analysis (often termed volumetric analysis in certain books), the substance to be determined is allowed to react with an appropriate reagent added as a standard solution, and the volume of solution needed for complete reaction is determined. The common types of reaction which are used in titrimetry are (a) neutralisation (acid-base) reactions (b) complex-forming reactions (c) precipitation reactions (d) oxidation-reduction reactions. [Pg.7]

One of the commonest procedures carried out by the analyst is the measurement of mass. Many chemical analyses are based upon the accurate determination of the mass of a sample, and that of a solid substance produced from it (gravimetric analysis), or upon ascertaining the volume of a carefully prepared standard solution (which contains an accurately known mass of solute) which is required to react with the sample (titrimetric analysis). For the accurate... [Pg.72]

The term titrimetric analysis refers to quantitative chemical analysis carried out by determining the volume of a solution of accurately known concentration which is required to react quantitatively with a measured volume of a solution of the substance to be determined. The solution of accurately known strength is called the standard solution, see Section 10.3. The weight of the substance to be determined is calculated from the volume of the standard solution used and the chemical equation and relative molecular masses of the reacting compounds. [Pg.257]

For use in titrimetric analysis a reaction must fulfil the following conditions. [Pg.258]

The reactions employed in titrimetric analysis fall into four main classes. The first three of these involve no change in oxidation state as they are dependent upon the combination of ions. But the fourth class, oxidation-reduction reactions, involves a change of oxidation state or, expressed another way, a transfer of electrons. [Pg.258]

Ethylenediaminetetra-acetic acid, largely as the disodium salt of EDTA, is a very important reagent for complex formation titrations and has become one of the most important reagents used in titrimetric analysis. Equivalence point detection by the use of metal-ion indicators has greatly enhanced its value in titrimetry. [Pg.259]

The word concentration is frequently used as a general term referring to a quantity of substance in a defined volume of solution. But for quantitative titrimetric analysis use is made of standard solutions in which the base unit of quantity employed is the mole. This follows the definition given by the International Union of Pure and Applied Chemistry1 in which ... [Pg.259]

Table 10.1 contains a list of indicators suitable for titrimetric analysis and for the colorimetric determination of pH. The colour-change intervals of most of the various indicators listed in the table are represented graphically in Fig. 10.1. [Pg.264]

See also in sourсe #XX -- [ Pg.32 , Pg.69 ]

See also in sourсe #XX -- [ Pg.94 ]

See also in sourсe #XX -- [ Pg.156 , Pg.157 ]

See also in sourсe #XX -- [ Pg.32 , Pg.69 ]

See also in sourсe #XX -- [ Pg.11 ]

See also in sourсe #XX -- [ Pg.461 , Pg.601 , Pg.607 ]

See also in sourсe #XX -- [ Pg.525 , Pg.701 , Pg.712 ]

See also in sourсe #XX -- [ Pg.3 , Pg.6 , Pg.7 , Pg.8 , Pg.30 , Pg.107 , Pg.135 ]

See also in sourсe #XX -- [ Pg.583 , Pg.732 , Pg.743 ]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...