Tris amine methanol oxidation

It is reported in the early literature that unsymmetrical amine oxides or those of high molecular weight cannot be prepared by the action of ozone on the amine. This study shows that an unsymmetrical amine oxide, such as N-ethylpiperidine oxide, and a symmetrical high molecular weight amine oxide, such as tri-n-hexylamine oxide, can be prepared by ozonization in methanol solution. [Pg.202]

Indirect electrochemical oxidation of substituted toluenes in methanol affords good yields of side chain substitution products, Tris(2,4-dibromophenyl)amine is... [Pg.198]

Technically interesting are the indirect electrochemical oxidations of benzylic alcohols (Table 11, No. 15-18) benzaldehyde dimethylacetals (Table 11, No. 19) and alkyl aromatic compounds (Table 11, No. 20, 21) It could be proven that benzylic alcohols are oxidizable using tris(2,4-dibromophenyl)amine as mediator not only in acetonitrile in a divided cell but also in methanol in an undivided cell... [Pg.56]

Anodic substitution can also occur easily in the a-position to heteroatoms like nitrogen or oxygen. Thus, the indirect electrochemical oxidation of ethylene glycol dimethyl ether in methanol using tris(2,4-dibromophenyl)amine as redox catalyst leads to the formation of 2-methoxyacetaldehyde dimethylacetal [25] ... [Pg.648]

In 1982 Foley and Btichi (182a) described a biomimetic synthesis of racemic dibromophakellin (137) via an oxidative cyclization of dihydroor-oidih (138). The ethyl ester of (+)-citrulline (139) was reduced with sodium amalgam and the crude aldehyde obtained was condensed with cyanamid and cyclized with hydrochloric acid, respectively, to give 140. Compound 140 was hydrolyzed to the amine 141. Acylation with 2,3-dibromo-5-tri-chloroacetylpyrrole yielded dihydrooroidin (138). Exposure of the hydrochloride of 138 to bromine in acetic acid and addition of methanol, followed by treatment with potassium /eri-butanolate gave racemic 137, identical to... [Pg.316]

An improved synthesis of dehydroascorbic acid has been reported (42). The oxidation of ascorbic acid in absolute methanol with oxygen over activated charcoal catalyst is reported to aflFord 28 in 95% yield. Dehydroascorbic acid has been characterized in solution as the monomer, 28 (43), and as the dimer (44,45) and its tetra acetyl derivative 29 (46). Several studies of mono- and di-hydrazone (48-53) and osazone (54) derivatives of dehydroascorbic acid have been reported. Hydrazone derivatives of dehydroascorbic acid have been used in the reductive synthesis of 2,3-diaza-2,3-dideoxy- and 2-aza-2-deoxyascorbic acid derivatives 30, 31, and 32 (55,56). Recently the reaction product of dehydro-L-ascorbic acid and L-phenylalanine in aqueous solution has been isolated and identified as tris(2-deoxy-2-L-ascorbyl)amine, 33, based on spectral and chemical data and its symmetry properties (57). [Pg.69]

Buffers used for air oxidation typically have pH values of 6.5-8.S, with the rate of oxidation higher with increasing pH (assuming that the substrate is soluble at the pH value chosen). The most widely used aqueous buffers are 0.1-0.2 M Tris-HCI or Tris-acetate, pH 7.7-e.7 0.01 M phosphate buffers, pH 7-8 0.2 M ammonium acetate, pH 6-7 and 0.01 M ammonium bicarbonate, pH 8. For the oxidation of certain iwptides, the use of organic co-solvents (methanol, acetonitrile, dioxane, TFE) and the addition of tertiary amines (NMM, EtsN, or DIPEA) Is recommended (72,80,81). Gdm-HCI (2-8 M) is sometimes added to aid in solubility, and to increase the conformational flexibility of peptides—this is reported to result in overall Improvements of the rates and yields of air oxidations. Addition of CuClj (0.1-1 p.M) has also been reported to improve certain oxidations. [Pg.95]

A study involving the peroxydisulfate oxidation products of the antimalarial drug primaquine (e.g., 6-methoxy-5,8-di-[4-amino-r-methylbuylamino]quinoline, N -tri-[4-amino-l-methylbutyl]amine) utilized a C,g colunrn (A = 254nm) and a 95/30/7/1 water/acetonitrile/methanol/water (IM perchloric acid) mobile phase [1497]. Primaquine dimers were also studied. The study followed the reaction of 250 pg/mL primaquine. All products were easily detectable. [Pg.514]

Route A utilizes the easily available 2-mercaptonicotinic acid as starting material. First, the nicotinic acid is esterified with acidic methanol to afford methyl 2-mercaptonicotinate, which is oxidized chlorine in aqueous acetic acid, followed amination with tert-butylamine, to give methyl 2-t-butylaminosulfonylnicotinate. This, in turn, is subjected to reaction with N,N-dimethylaminodimethylaluminum to afford a nicotinamide, which is finally converted to the target intermediate by de-butylation using tri-fluoroacetic acid. [Pg.103]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...