Film, two-, theory

The connection between the film mass transfer coefficients and the over-all mass transfer coefficients is provided by the two-film theory from Lewis and Whitman (1924) the total resistance to mass transfer is the sum of the resistances in each phase. [Pg.87]

Rearranging equation 3-8 yields an equation relating the over-all mass transfer coefficient to the individual film coefficients [Pg.87]

In cases where the major resistance is in the liquid phase, the ratio RL/ RT= 1 and the simplification can be made that the over-all coefficient is equal to the liquid film coefficient. Which resistance dominates has to be determined from the ratio kLa / (kGa Hc) (Table 3-3). For compounds with a low Hc such as semi-volatile organic compounds, both resistances can be important (Libra, 1993). In oxygen transfer the liquid-side resistance dominates and KLa = kLa. This is also true for most of the cases in ozone mass transfer, unless there is strong mass transfer enhancement by very fast or instantaneous reactions of [Pg.87]

The models discussed above will now be applied to the situation of transfer accompanied by reaction. We first use the two-film theory, then the surface renewal theory. The literature on the subject is overwhelming, and no attennpt is made to be complete. Instead, the general concepts are synthesized and illustrated. More extensive coverage can be found in several textbooks more oriental toward gas absorption [39,40,41,42,43]. [Pg.308]

In a reactor working under normal operating conditions, meaning the heat exchange system is working as designed, the mechanism of heat transfer is forced [Pg.219]

The first term depends entirely on the physical properties of the reactor contents and degree of agitation. It represents resistance to heat transfer of the internal film and of eventual deposits at the wall, which may determine the overall heat transfer [3], Therefore, the reactor should be regularly cleaned with a high pressure cleaner. Both last terms depend on the reactor itself and on the heat exchange system, that is, reactor wall, fouling in the jacket, and external liquid film. They are often grouped under one term the equipment heat transfer coefficient (cp) [4, 5], [Pg.220]

For description of the heat transfer coefficient of the internal film, there are several correlations available. The most popular of them is presented by [2] [Pg.220]

Here the Reynolds number is expressed for a stirred tank where the flow rate corresponds to the tip speed (n-ds) of the agitator. [Pg.221]

Twin-fluid atomizer Twisted pair cable Twitchell splitting Twitchell s reagents Two-film theory... [Pg.1032]

Fig. 2. Schematic representation for the two-film theory of gas transfer = partial pressure of gas Pj = partial pressure of the gas at the interface Cj = concentration of gas at time t, Cj = initial concentration of gas at the interface Cg = initial concentration of gas at t = 0 and S = gas saturation.

F = Function of the molecular volume of the solute. Correlations for this parameter are given in Figure 7 as a function of the parameter (j), which is an empirical constant that depends on the solvent characteristics. As points of reference for water, (j) = 1.0 for methanol, (j) = 0.82 and for benzene, (j) = 0.70. The two-film theory is convenient for describing gas-liquid mass transfer where the pollutant solute is considered to be continuously diffusing through the gas and liquid films. [Pg.257]

Because of the difficulties in determining x, the thickness of the film between the two vapor pressures, an overall transfer coefficient is introduced. Based on the two film theory, the overall transfer coefficient is used. In the case of water evaporation, the gas film is the controlling mechanism and the resulting equation is... [Pg.1359]

The two-film theory of WHITMAN119 was the first serious attempt to represent conditions occurring when material is transferred from one fluid stream to another. Although it does not closely reproduce the conditions in most practical equipment, the theory gives expressions which can be applied to the experimental data which are generally available, and for that reason it is still extensively used. [Pg.600]

From equation 10.22 the rate of transfer per unit area in terms of the two-film theory for equimolecular counterdiffusion is given for the first phase as ... [Pg.601]

If it is assumed that each element resides for the same time interval te in the surface, equation 10.115 gives the overall mean rate of transfer. It may be noted that the rate is a linear- function of the driving force expressed as a concentration difference, as in the two-film theory, but that it is proportional to the diffusivity raised to the power of 0.5 instead of unity. [Pg.606]

When the film theory is applicable to each phase (the two-film theory), the process is steady state throughout and the interface composition does not then vary with time. For this case the two film coefficients can readily be combined. Because material does not accumulate at the interface, the mass transfer rate on each side of the phase boundary will be the same and for two phases it follows that ... [Pg.619]

These relations between the various coefficients are valid provided that the transfer rate is linearly related to the driving force and that the equilibrium relationship is a straight line. They are therefore applicable for the two-film theory, and for any instant of time for the penetration and film-penetration theories. In general, application to time-averaged coefficients obtained from the penetration and film-penetration theories is not permissible because the condition at the interface will be time-dependent unless all of the resistance lies in one of the phases. [Pg.620]

As noted previously, for equimolecular counterdiffusion, the film transfer coefficients, and hence the corresponding HTUs, may be expressed in terms of the physical properties of the system and the assumed film thickness or exposure time, using the two-film, the penetration, or the film-penetration theories. For conditions where bulk flow is important, however, the transfer rate of constituent A is increased by the factor Cr/Cgm and the diffusion equations can be solved only on the basis of the two-film theory. In the design of equipment it is usual to work in terms of transfer coefficients or HTUs and not to endeavour to evaluate them in terms of properties of the system. [Pg.625]

According to the Whitman Two-Film theory, the actual concentration profiles, as shown in Fig. 1.28 are approximated for the steady state with no chemical reaction, by that of Fig. 1.29. [Pg.61]

Figure 1.29. Concentration gradients according to the Two-Film theory.

Note that the transfer rate equation is based on an overall concentration driving force, (X-X ) and overall mass transfer coefficient, Kl. The two-film theory for interfacial mass transfer shows that the overall mass transfer coefficient, Kl, based on the L-phase is related to the individual film coefficients for the L and G-phase films, kL and ko, respectively by the relationship... [Pg.168]

The experiments were conducted at four different temperatures for each gas. At each temperature experiments were performed at different pressures. A total of 14 and 11 experiments were performed for methane and ethane respectively. Based on crystallization theory, and the two film theory for gas-liquid mass transfer Englezos et al. (1987) formulated five differential equations to describe the kinetics of hydrate formation in the vessel and the associate mass transfer rates. The governing ODEs are given next. [Pg.314]

The approach taken is semi-empirical. Point efficiencies are estimated making use of the two-film theory , and the Murphree efficiency estimated allowing for the degree of mixing likely to be obtained on real plates. [Pg.553]

Two-film theory (Lewis and Whitman, 1924) the theory is based on molecular diffusion through two stagnant films, a liquid and a gas film, at the air-water interface. [Pg.73]

The two-film theory considering molecular diffusion through stagnant liquid and gas films is the traditional way of understanding mass transfer across the air-water boundary. As briefly described, other theories exist. However, the two-film theory gives an understanding of fundamental phenomena that may lead to simple empirical expressions for use in practice. [Pg.73]

The transport process, according to the two-film theory, of a volatile component across the air-water interface is depicted in Figure 4.3. The figure illustrates a concept that concentration gradients in both phases exist and that the total resistance for mass transfer is the sum of the resistance in each phase. [Pg.74]

Although mass transfer across the water-air interface is difficult in terms of its application in a sewer system, it is important to understand the concept theoretically. The resistance to the transport of mass is mainly expected to reside in the thin water and gas layers located at the interface, i.e., the two films where the gradients are indicated (Figure 4.3). The resistance to the mass transfer in the interface itself is assumed to be negligible. From a theoretical point of view, equilibrium conditions exist at the interface. Because of this conceptual understanding of the transport across the air-water boundary, the theory for the mass transport is often referred to as the two-film theory (Lewis and Whitman, 1924). [Pg.74]

According to the two-film theory, it is appropriate to consider the transport of volatile components between the water phase and the air phase in two steps from the bulk water phase to the interface and from the interface to the air, or vice versa. The driving force for the transfer of mass per unit surface area from the water phase to the interface and from the interface to the air phase is determined from the difference between the actual molar fractions, xA and yA, and the corresponding equilibrium values, xA and yA ... [Pg.74]

Gas absorption. See also Absorption ion exchange in, 14 423 measurement equation for, 24 456-457 two-film theory of, 26 154—158 Gas-air explosions, prevention of,... [Pg.390]

A relation between dy/dZ and (Ay)/ may be obtained on the basis of the two-film theory of mass transfer. For the vapour film, Fick s law, Volume 1, Chapter 10, gives ... [Pg.641]

The preceding analysis of the process of absorption is based on the two-film theory of Whitman 11. It is supposed that the two films have negligible capacity, but offer all the resistance to mass transfer. Any turbulence disappears at the interface or free surface, and the flow is thus considered to be laminar and parallel to the surface. [Pg.659]

See also in sourсe #XX -- [ Pg.250 ]

See also in sourсe #XX -- [ Pg.73 , Pg.74 , Pg.75 , Pg.76 ]

See also in sourсe #XX -- [ Pg.46 , Pg.131 ]

See also in sourсe #XX -- [ Pg.47 ]

See also in sourсe #XX -- [ Pg.219 , Pg.336 ]

See also in sourсe #XX -- [ Pg.367 , Pg.368 , Pg.369 , Pg.370 , Pg.371 , Pg.528 , Pg.529 , Pg.532 ]

See also in sourсe #XX -- [ Pg.250 ]

See also in sourсe #XX -- [ Pg.91 ]

See also in sourсe #XX -- [ Pg.56 , Pg.161 ]

See also in sourсe #XX -- [ Pg.250 ]

See also in sourсe #XX -- [ Pg.600 ]

See also in sourсe #XX -- [ Pg.308 ]

See also in sourсe #XX -- [ Pg.367 , Pg.368 , Pg.369 , Pg.370 , Pg.371 , Pg.528 , Pg.529 , Pg.532 ]

See also in sourсe #XX -- [ Pg.91 ]

See also in sourсe #XX -- [ Pg.118 , Pg.119 , Pg.120 , Pg.121 ]

See also in sourсe #XX -- [ Pg.142 ]

See also in sourсe #XX -- [ Pg.217 ]

See also in sourсe #XX -- [ Pg.323 ]

See also in sourсe #XX -- [ Pg.24 ]

See also in sourсe #XX -- [ Pg.50 , Pg.51 , Pg.118 , Pg.305 ]

See also in sourсe #XX -- [ Pg.107 , Pg.110 ]

See also in sourсe #XX -- [ Pg.33 ]

See also in sourсe #XX -- [ Pg.719 ]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...