Home
Author Guide
Editor Guide
Reviewer Guide
Special Issues
Special Issue Introduction
Special Issues List
Topics
Published Issues
2024
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
2013
2012
2010
2009
2008
2007
2006
journal menu
Aims and Scope
Editorial Board
Indexing Service
Article Processing Charge
Open Access Policy
Publication Ethics
Digital Preservation Policy
Editorial Process
Subscription
Contact Us
General Information
ISSN:
1796-2021 (Online); 2374-4367 (Print)
Abbreviated Title:
J. Commun.
Frequency:
Monthly
DOI:
10.12720/jcm
Abstracting/Indexing:
Scopus
;
DBLP
;
CrossRef
,
EBSCO
,
Google Scholar
;
CNKI,
etc.
E-mail questions
or comments to
[email protected]
Acceptance Rate:
27%
APC:
800 USD
Average Days to Accept:
88 days
3.4
2023
CiteScore
51st percentile
Powered by
Article Metrics in Dimensions
Editor-in-Chief
Prof. Maode Ma
College of Engineering, Qatar University, Doha, Qatar
I'm very happy and honored to take on the position of editor-in-chief of JCM, which is a high-quality journal with potential and I'll try my every effort to bring JCM to a next level...
[Read More]
What's New
2024-10-16
Vol. 19, No. 10 has been published online!
2024-08-20
Vol. 19, No. 8 has been published online!
2024-07-22
Vol. 19, No. 7 has been published online!
Home
>
Published Issues
>
2019
>
Volume 14, No. 8, August 2019
>
IoT Technologies for Mobile Crowd Sensing in Smart Cities
Abbas M. Ali Al-muqarm and Furkan Rabee
Computer Science Department, Faculty of Computer Science and Mathematics, University of Kufa, Iraq
Abstract
—Internet of Things is a sophisticated concept of the Internet, so all things in our lives can be connected to the Internet or to each other to send and receive data to perform specific functions through the network. The Mobile Crowd Sensing (MCS) technology is used by users who use a smartphone as a new direction in the development of the Internet of Things. The volunteers rely on collecting data from the environment by taking advantage of smartphone features such as (camera, temperature, GPS, Microphone, etc.).There are two challenges with MCS are Battery power consumption and the cost of data upload. This paper presented a new framework called Efficient power consumption (EPC - MCS) based on the use of one of the IoT protocols for the limited devices resources such as( power, memory, and processing, etc.) which is the CoAP protocol after comparing its performance with the protocols (MQTT and XMPP) by simulation proved to be power efficient. This framework proposes dividing the MCS area into two areas , Global mobile node, and local mobile node, volunteers in the global area are collecting data by using their smartphone and sending data to the local area, that might be smartphone, computers or other existing devices at home or a health center. If a local nodes uploading the data to a switch, the switch will route the data to the gateway which has two choices: If there is a need to make a quick decision, should be switched to the fog layer, else uploading the data to the cloud via a Wi-Fi or a 3G connection with a piggyback. Thus, yield two advantages are Zero cost for uploading data and less energy consumption. In this paper, we presented an algorithm to route the data between the global nodes and local nodes with fog computing and without. Evaluate the performance of our framework through use cooja emulator show to be effective in efficient power consumption and data uploading, compared to previous articles in the same subject.
Index Terms
—Internet of Things (IoT), Mobile crowd sensing (MCS), smart cities, fog computing, CoAP
Cite: Abbas M. Ali Al-muqarm and Furkan Rabee, "IoT Technologies for Mobile Crowd Sensing in Smart Cities," Journal of Communications, vol. 14, no. 8, pp. 745-757, 2019. Doi: 10.12720/jcm.14.8.745-757
15-JCM170250
PREVIOUS PAPER
Performance Analysis of Adaptive Fuzzy Spray and Wait Routing Protocol
NEXT PAPER
Last page