Rotation (aeronautics)

(Redirected from Rotation (aviation))

In aviation, rotation refers to the action of applying back pressure to a control device, such as a yoke, side-stick or centre stick, to lift the nose wheel off the ground during takeoff. An aircraft moves at any given moment in one or more of three axes: roll (the axis that runs the length of the fuselage), pitch (the axis running laterally through the wings), and yaw (the vertical axis around which the front of the aircraft turns to the left or right whilst its rear turns toward the opposite direction). Displacement along any of these axes is a form of rotation, but the term "rotation" in relation to takeoff is limited to the moment during which the aircraft's nose rises from the ground: the aircraft rotates around its lateral axis.

An Aeroflot Il-96 rotating.

The first critical speed during takeoff (at which a pilot must decide whether to continue with takeoff or abort it) is called the "decision speed", or V1, beyond which it would be unsafe to abort the takeoff. Rotation is begun at the speed known as VR. Rotation at the correct speed and to the correct angle is important for safety reasons and to minimise takeoff distance.[1] After rotation, the aircraft continues to accelerate until it reaches its liftoff speed VLO, at which point it leaves the runway. After liftoff, a speed V2 will be called out, being the speed at which the aircraft is able to climb at a sufficient rate to reach its cruising altitude, and therefore at which the gear will be retracted.[2] Early or over-rotation can cause a tailstrike, which can damage the underside of the tail unless prevented by a protection device such as a tailskid or tail bumper. A certification test is required to show that a new aircraft design will still take off safely with the tail dragging on the runway. Using a higher VR will increase tail clearance and reduce the probability of tailstrike. Over-rotation can also result in loss of lift, causing a stall.

Description

edit

Rotation applies to tricycle gear aircraft rather than those with conventional gear (tailwheel aircraft). The on-ground angle of attack of the wing has to be established during the design phase. The main and nose-gear leg lengths are chosen to give a negative angle of attack relative to the ground. This ensures the wing will have negative lift until the pilot rotates the aircraft to a positive angle of attack. During landing, the reverse happens when the nose-wheel touches the runway and the wing assumes a negative angle of attack with no lift.

For aircraft with a tailwheel, the pilot initially pushes forward on the yoke during the takeoff run, lifting the tailwheel off the runway, and the aircraft lifts off the runway once sufficient speed is achieved.[3]

References

edit
  1. ^ Christopher L. Parker. "Normal Takeoff and Climb". AOPA. Retrieved 10 July 2010.
  2. ^ Lorraine de Baudus & Philippe Castaigns. "Control your speed… at take-off". Airbus. Retrieved 20 January 2024.
  3. ^ "Flying Magazine". April 2002: 96. Retrieved 13 October 2022. {{cite journal}}: Cite journal requires |journal= (help)