Advances in the performance of low- and high-temperature superconductors enable the development of advanced magnets for a range of applications, including tokamaks for fusion energy, dipoles, and quadrupoles for hadron colliders, and solenoids for nuclear magnetic resonance studies. The capability of testing prototype cables and insert coils at high field is critical to these developments. We present here the conceptual design of a test facility dipole with features suitable to support the advanced magnet development efforts of both Fusion and HEP communities. In particular, a background field of 15 T is provided over a minimum homogeneous length of 1000 mm, and the magnet clear bore of approximately 144 × 94 mm can accommodate large fusion conductors as well as prototype coils for high field dipoles, along with flexible cryogenic and mechanical provisions for sample characterization. Two technical solutions are considered. The first uses a forced flow cable-in-conduit conductor and follows the design developed by EFDA for the EDIPO magnet. The second uses a bath cooled Rutherford cable and follows a block-coil design similar to the CERN FRESCA2 dipole, and the LBNL HD and LD1 dipoles. Following a comparison between the two approaches, we present two designs for the Rutherford cable approach including performance objectives, key parameters, and preliminary magnetic, mechanical and quench protection analysis.

A large aperture Nb 3 Sn dipole is proposed to replace the magnet assembly of EDIPO, which was irreversibly damaged in 2016. The goal is to generate a background field of 15 T at 4.2 K in a clear aperture of approximately 100×150 mm 2 and over a uniform length of 1000 mm in order to test superconducting cables for both fusion and high-energy physics applications. The magnet features a block-type coil design wound with wide Rutherford cable (two alternative coil cross sections are considered) and supported by a mechanical structure based on keys-and-bladders technology. In the end regions, the coils tilt up (flare) through a hard-way bend of the cables to provide room for the test well, following a layout already adopted in the LBNL HD2 and CERN-CEA FRESCA2 magnets. The two considered coil design alternatives aim at minimizing the mechanical stress in the coil windings. One coil pack design makes the use of two double pancake coils per pole, whereas the other alternative features three double pancakes per pole. Both design options are presented focusing on the results of numerical computations carried out with finite-element models to investigate peak stresses in the coils during room-temperature pre-loading, cool down, and powering.

A muon collider would enable the big jump ahead in energy reach that is needed for a fruitful exploration of fundamental interactions. The challenges of producing muon collisions at high luminosity and 10 TeV centre of mass energy are being investigated by the recently-formed International Muon Collider Collaboration. This Review summarises the status and the recent advances on muon colliders design, physics and detector studies. The aim is to provide a global perspective of the field and to outline directions for future work.

The original online version of this article was revised: The additional reference [139] has been added. Tao Han’s ORICD ID has been incorrectly assigned to Chengcheng Han and Chengcheng Han’s ORCID ID to Tao Han. Yang Ma’s ORCID ID has been incorrectly assigned to Lianliang Ma, and Lianliang Ma’s ORCID ID to Yang Ma. The original article has been corrected.