ADC_M5StickC.ino

/*
*******************************************************************************
* Copyright (c) 2021 by M5Stack
*                  Equipped with M5StickC sample source code
*                          配套  M5StickC 示例源代码
* Visit for more information: https://docs.m5stack.com/en/unit/adc
* 获取更多资料请访问: https://docs.m5stack.com/zh_CN/unit/adc
*
* Product:  ADC.  A/D转换器
* Date: 2022/7/11
*******************************************************************************
  Please connect to Port,Use ADC Unit to convert 0 ~ 12V analog voltage into
  16-bit data and display it on the screen.
  请连接端口,利用ADC单元将0 ~12V模拟电压转换成16位数据显示在屏幕上。
*/

#include <M5StickC.h>
#include "M5_ADS1100.h"

ADS1100 ads;

void setup(void) {
    M5.begin();             // Init M5StickC.  初始化M5StickC
    M5.Lcd.setRotation(3);  // Rotating display.  旋转显示屏

    // The address can be changed making the option of connecting multiple
    // devices 地址可以改变，以连接多个设备
    ads.getAddr_ADS1100(
        ADS1100_DEFAULT_ADDRESS);  // 0x48, 1001 000 (ADDR = GND)

    // The ADC gain (PGA).  ADC增益(PGA)
    ads.setGain(GAIN_ONE);  // 1x gain(default)
    // ads.setGain(GAIN_TWO);       // 2x gain
    // ads.setGain(GAIN_FOUR);      // 4x gain
    // ads.setGain(GAIN_EIGHT);     // 8x gain

    // Device operating mode.  设备工作模式
    ads.setMode(MODE_CONTIN);  // Continuous conversion mode (default)
    // ads.setMode(MODE_SINGLE);    // Single-conversion mode

    // Data rate.  数据速率
    ads.setRate(RATE_8);  // 8SPS (default)
    // ads.setRate(RATE_16);        // 16SPS
    // ads.setRate(RATE_32);        // 32SPS
    // ads.setRate(RATE_128);       // 128SPS

    ads.setOSMode(
        OSMODE_SINGLE);  // Set to start a single-conversion.  设置开始一次转换

    ads.begin();  // Sets up the Hardware.  设置硬件
    M5.Lcd.print("ADC");
}

void loop(void) {
    byte error;
    int8_t address;

    address = ads.ads_i2cAddress;
    Wire.beginTransmission(address);
    error = Wire.endTransmission();
    if (error == 0)  // If the device is connected.  如果连接上设备
    {
        int16_t result;
        result = ads.Measure_Differential();
        M5.Lcd.fillScreen(BLACK);
        char data[20] = {0};
        sprintf(data, "%d", result);
        M5.Lcd.drawCentreString(data, 0, 20, 4);
    } else {
        M5.Lcd.setCursor(0, 40);
        M5.Lcd.drawString("No Found ADC sensor.", 0, 20);
    }
    delay(1000);
}