Abstract

We demonstrate a simulation of a parallel hybrid fiber amplifier in the C+L-band with a gain controlling technique. A variable optical coupler is used to control the input signal power for both EDFA and RFA branches. The gain spectra of the C+L-band are flattened by optimizing the coupling ratio of the input signal power. In order to enhance the pump conversion efficiency, the EDFA branch was pumped by the residual Raman pump power. A gain bandwidth of 60 nm from 1530 nm to 1590 nm is obtained with large input signal power less than -5 dBm. The gain variation is about 1.06 dB at a small input signal power of -30 dBm, and it is reduced to 0.77 dB at the large input signal power of -5 dBm. The experimental results show close agreement with the simulation results.

© 2014 Optical Society of Korea

L-band automatic-gain-controlled erbium-doped fiber amplifier utilizing C-band backward-amplified spontaneous emission and electrical feedback monitor

Jyi-Lai Shen, Yueh-Chien Lee, and Chia-Chih Huang
Appl. Opt. 48(5) 842-846 (2009)

Low noise figure all-optical gain-clamped parallel C+L band Erbium-doped fiber amplifier using an interleaver

L. L. Yi, L. Zhan, C. S. Taung, S. Y. Luo, W. S. Hu, Y. K. Su, Y. X. Xia, and Lufeng Leng
Opt. Express 13(12) 4519-4524 (2005)

Wideband full double-pass serial hybrid fiber amplifier utilizing L-shape configuration

Aseel A. Khudhair, M. H. Ali, and A. K. Abass
Appl. Opt. 60(34) 10680-10683 (2021)

Opto-optical gain-clamped L-band erbium-doped fiber amplifier with C-band control signal

A. A. A. Bakar, M. A. Mahdi, M. H. Al-Mansoori, S. Shaari, and A. K. Zamzuri
Appl. Opt. 48(12) 2340-2343 (2009)

Noise evolution with the phase-sensitive gain in a hybrid fiber phase-sensitive amplifier

Zhanchang Liu, Zhirong Chen, Xiaojie Guo, Jiangbing Du, and Zhaohui Li
Opt. Lett. 45(11) 3075-3078 (2020)