Are you looking for tips on how to remove lawn mower blades? You have probably seen them on TV or in magazine ads, but most of them are just plain crazy.
The problem is that some people think they are impossible to do, and others believe that they are the only way to get a free lawn mower that won’t break.
You can follow several steps to do the job yourself without hiring someone to do it for you.
To do the job yourself, first, you will need these items: 5/8 inch socket, a socket wrench will come in handy if you need to take apart the wheel (it’s not recommended because it’s not designed to be opened with one hand), Use a small wrench to remove the lawn mower’s blade and ratchet wrench in one fluid motion, a ratchet wrench.
source: homeguidessfgate.com
Then you will need to remove the nuts that hold the wheels in place to remove them. To replace the lawnmower blades, turn the lawnmower back on to access the cutting blade, but keep it on the side and pull it toward the back to allow the motor to run a little bit.
Once the bolts that hold the wheels in place have been removed, slide the nut that holds the blade onto the bolt that holds the cutting blade on the other side.
Turn the best lawn mower in reverse, to remove the old blade from the disk. Remove the nuts that hold the two halves of the wheel in place.
source: sodsolutions.com
Put the new blades in place, then tighten them using the wrench. Screw the nuts back into the bolts. Then screw the nuts onto the wheels. You may also want to secure the wheel itself with screws.
Next, screw into the bolts that hold the pulley, and then tighten them. Tighten the nuts that hold the motor bracket in place. Turn on the lawn mower and make sure everything is tight and working smoothly.
Third, you can start the process of replacing the battery in the battery pack. so that it’s ready to use. start off by disconnecting the battery cables and removing the battery tray, and plugging them into a different terminal in your vehicle.
source: pinterest.com
Fourth, check and reconnect the wiring and make sure all the wires are tied together. Also, plug the battery into the cigarette lighter so that you don’t have to fumble with cables or mess with wires.
Put the new lawn mowers in place. Run a wire down through the hole, then run another wire up through the hole in the battery tray.
Fifth, attach the battery tray to the battery pack to connect the battery pack to the new blade. Sixth, reconnect the chainsaw’s chain so that the chainsaw can be attached.
Finally, connect the electric motor and plug the chain clamp to the lawn mowing mechanism. If you’re a handyman, you could probably make your chainsaw motor out of wire and a few pieces of pipe to save money.
source: wikipedia.org
But if not, use zip ties to connect the chain to the chain clamp and motor, and make sure that the engine is installed correctly.
The final step is to turn on the chainsaw and run it a little while to let the engine warm up. This will ensure that the new lawnmower blade is installed correctly and has the right amount of power.
While the lawn mower is running, you can change the lawn mower blade for another. If the blade is damaged or doesn’t fit, you could quickly put a new one in to replace it, although these repairs are relatively minor.
For some people, these lawn mower blades and lawnmowers are as crucial as their lawnmower. engines. They often replace them, since they aren’t usually used very much.
