An aerosol-enabled globally driven regional modeling system has been developed by coupling the National Center for Atmospheric Research’s Community Atmosphere Model version 5 (CAM5) with the Weather Research and Forecasting model with chemistry (WRF-Chem). In this modeling system, aerosol-enabled CAM5, a state-of-the-art global climate model is downscaled to provide coherent meteorological and chemical boundary conditions for regional WRF-Chem simulations. Aerosol particle emissions originating outside the WRF-Chem domain can be a potentially important nonlocal aerosol source. As a test case, the potential impacts of nonlocal forest fire aerosols on regional precipitation and radiation were investigated over the northeastern United States during the summer of 2004. During this period, forest fires in Alaska and western Canada lofted aerosol particles into the midtroposphere, which were advected across the United States. WRF-Chem simulations that included nonlocal biomass burning aerosols had domain-mean aerosol optical depths that were nearly three times higher than those without, which reduced peak downwelling domain-mean shortwave radiation at the surface by ~25 W m-2. In this classic twin experiment design, adding nonlocal fire plume led to near-surface cooling and changes in cloud vertical distribution, while variations in domain-mean cloud liquid water path were negligible. The higher aerosol concentrations in the simulation with the fire plume resulted in a ~10%reduction in domain-mean precipitation coincident with an ~8%decrease in domain-mean CAPE. A suite of simulations was also conducted to explore sensitivities of meteorological feedbacks to the ratio of black carbon to total plume aerosols, as well as to overall plume concentrations. Results from this ensemble revealed that plume-induced near-surface cooling and CAPE reduction occur in a wide range of conditions. The response of moist convection was very complex because of strong thermodynamic internal variability.

Biogenic lipids and polymers are surveyed for their ability to adsorb at the water-air interfaces associated with bubbles, marine microlayers and particles in the overlying boundary layer. Representative ocean biogeochemical regimes are defined in order to estimate local concentrations for the major macromolecular classes. Surfactant equilibria and maximum excess are then derived based on a network of model compounds. Relative local coverage and upward mass transport follow directly, and specific chemical structures can be placed into regional rank order. Lipids and denatured protein-like polymers dominate at the selected locations. The assigned monolayer phase states are Variable, whether assessed along bubbles or at the atmospheric spray droplet perimeter. Since oceanic film compositions prove to be irregular, effects on gas and organic transfer are expected to exhibit geographic dependence as well. Moreover, the core arguments extend across the sea-air interface into aerosol-cloud systems. Fundamental nascent chemical properties including mass to carbon ratio and density depend strongly on the geochemical state of source waters. High surface pressures may suppress the Kelvin effect, and marine organic hygroscopicities are almost entirely unconstrained. While bubble adsorption provides a well-known means for transporting lipidic or proteinaceous material into sea spray, the same cannot be said of polysaccharides. Carbohydrates tend to be strongly hydrophilic so that their excess carbon mass is low despite stacked polymeric geometries. Since sugars are abundant in the marine aerosol, gel-based mechanisms may be required to achieve uplift. Uncertainties distill to a global scale dearth of information regarding two dimensional kinetics and equilibria. Nonetheless simulations are recommended, to initiate the process of systems level quantification. © 2014 IOP Publishing Ltd.

The presence of a large fraction of organic matter in primary sea spray aerosol (SSA) can strongly affect its cloud condensation nuclei activity and interactions with marine clouds. Global climate models require new parameterizations of the SSA composition in order to improve the representation of these processes. Existing proposals for such a parameterization use remotely sensed chlorophyll a concentrations as a proxy for the biogenic contribution to the aerosol. However, both observations and theoretical considerations suggest that existing relationships with chlorophyll a, derived from observations at only a few locations, may not be representative for all ocean regions. We introduce a novel framework for parameterizing the fractionation of marine organic matter into SSA based on a competitive Langmuir adsorption equilibrium at bubble surfaces. Marine organic matter is partitioned into classes with differing molecular weights, surface excesses, and Langmuir adsorption parameters. The classes include a lipid-like mixture associated with labile dissolved organic carbon (DOC), a polysaccharide-like mixture associated primarily with semilabile DOC, a protein-like mixture with concentrations intermediate between lipids and polysaccharides, a processed mixture associated with recalcitrant surface DOC, and a deep abyssal humic-like mixture. Box model calculations have been performed for several cases of organic adsorption to illustrate the underlying concepts. We then apply the framework to output from a global marine biogeochemistry model, by partitioning total dissolved organic carbon into several classes of macromolecules. Each class is represented by model compounds with physical and chemical properties based on existing laboratory data. This allows us to globally map the predicted organic mass fraction of the nascent submicron sea spray aerosol. Predicted relationships between chlorophyll a and organic fraction are similar to existing empirical parameterizations, but can vary between biologically productive and nonproductive regions, and seasonally within a given region. Major uncertainties include the bubble film thickness at bursting, and the variability of organic surfactant activity in the ocean, which is poorly constrained. In addition, polysaccharides may enter the aerosol more efficiently than Langmuir adsorption would suggest. Potential mechanisms for enrichment of polysaccharides in sea spray include the formation of marine colloidal particles that may be more efficiently swept up by rising bubbles, and cooperative adsorption of polysaccharides with proteins or lipids. These processes may make important contributions to the aerosol, but are not included here. This organic fractionation framework is an initial step towards a closer linking of ocean biogeochemistry and aerosol chemical composition in Earth system models. Future work should focus on improving constraints on model parameters through new laboratory experiments or through empirical fitting to observed relationships in the real ocean and atmosphere, as well as on atmospheric implications of the variable composition of organic matter in sea spray.

Aerosol produced during the burning of olive tree branches was characterized with both direct source sampling (using a mobile smog chamber) and with ambient measurements during the burning season. The fresh particles were composed of 80% organic matter, 8-10% black carbon (BC), 5% potassium, 3-4% sulfate, 2-3% nitrate and 0.8% chloride. Almost half of the fresh olive tree branches burning organic aerosol (otBB-OA) consisted of alkane groups. Their mode diameter was close to 70 nm. The oxygen to carbon (O : C) ratio of the fresh otBB-OA was 0.29 ± 0.04. The mass fraction of levoglucosan in PM1 was 0.034-0.043, relatively low in comparison with most fuel types. This may lead to an underestimation of the otBB-OA contribution if levoglucosan is being used as a wood burning tracer. Chemical aging was observed during smog chamber experiments, as f 44 and O : C ratio increased, due to reactions with OH radicals and O3. The otBB-OA AMS mass spectrum differs from the other published biomass burning spectra, with a main difference at m/z 60, used as levoglucosan tracer. In addition to particles, volatile organic compounds (VOCs) such as methanol, acetonitrile, acrolein, benzene, toluene and xylenes are also emitted. Positive matrix factorization (PMF) was applied to the ambient organic aerosol data and 3 factors could be identified: OOA (oxygenated organic aerosol, 55%), HOA (hydrocarbon-like organic aerosol, 11.3%) and otBB-OA 33.7%. The fresh chamber otBB-OA AMS spectrum is close to the PMF otBB-OA spectrum and resembles the ambient mass spectrum during olive tree branches burning periods. We estimated an otBB-OA emission factor of 3.5 ± 0.9 g kg-1. Assuming that half of the olive tree branches pruned is burned in Greece, 2300 ± 600 tons of otBB-OA are emitted every year. This activity is one of the most important fine aerosol sources during the winter months in Mediterranean countries. © 2013 Author(s).

Size-resolved observations of aerosol particles and cloud droplet residuals were studied at a marine boundary layer site (251 m a.m.s.l.) in La Jolla, San Diego, California, during 2012. A counterflow virtual impactor (CVI) was used as the inlet to sample cloud residuals while a total inlet was used to sample both cloud residuals and interstitial particles. Two cloud events totaling 10 h of in-cloud sampling were analyzed. Based on bulk aerosol particle concentrations, mass concentrations of refractory black carbon (rBC), and back trajectories, the two air masses sampled were classified as polluted marine air. Since the fraction of cloud droplets sampled by the CVI was less than 100%, the measured activated fractions of rBC should be considered as lower limits to the total fraction of rBC activated during the two cloud events. Size distributions of rBC and a coating analysis showed that sub-100 nm rBC cores with relatively thick coatings were incorporated into the cloud droplets (i.e., 95 nm rBC cores with median coating thicknesses of at least 65 nm were incorporated into the cloud droplets). Measurements also show that the coating volume fraction of rBC cores is relatively large for sub-100 nm rBC cores. For example, the median coating volume fraction of 95 nm rBC cores incorporated into cloud droplets was at least 0.9, a result that is consistent with °-Köhler theory. Measurements of the total diameter of the rBC-containing particles (rBC core and coating) suggest that the total diameter of rBC-containing particles needed to be at least 165 nm to be incorporated into cloud droplets when the core rBC diameter is g‰¥ 85 nm. This result is consistent with previous work that has shown that particle diameter is important for activation of non-rBC particles. The activated fractions of rBC determined from the measurements ranged from 0.01 to 0.1 for core rBC diameters ranging from 70 to 220 nm. This type of data is useful for constraining models used for predicting rBC concentrations in the atmosphere.

To study the effect of giant cloud condensation nuclei (GCCN) on precipitation processes in stratocumulus clouds, 1-10 μm diameter salt particles (salt powder) were released from an aircraft while flying near the cloud top on 3 August 2011 off the central coast of California. The seeded area was subsequently sampled from the aircraft that was equipped with aerosol, cloud, and precipitation probes and an upward-facing cloud radar. During post-seeding sampling, made 30-60 min after seeding, the mean cloud droplet size increased, the droplet number concentration decreased, and large drop (e.g., diameter larger than 10 μm) concentration increased. Average drizzle rates increased from about 0.05 to 0.20 mm h^-1, and the liquid water path decreased from about 52 to 43 g m^-2. Strong radar returns associated with drizzle were observed on the post-seeding cloud-base level-leg flights and were accompanied by a substantial depletion of the cloud liquid water content. The changes were large enough to suggest that the salt particles with concentrations estimated to be 10^-2 to 10^-4 cm^-3 resulted in a four-fold increase in the cloud-base rainfall rate and depletion of the cloud water due to rainout. In contrast, a case is shown where the cloud was already precipitating (on 10 August) and the effect of adding GCCN to the cloud was insignificant.

Physical and biogeochemical processes in seawater controlling primary marine aerosol (PMA) production and composition are poorly understood and associated with large uncertainties in estimated fluxes into the atmosphere. PMA production was investigated in the biologically productive NE Pacific Ocean and in biologically productive and oligotrophic regions of the NW Atlantic Ocean. Physicochemical properties of model PMA, produced by aeration of fresh seawater under controlled conditions, were quantified. Diel variability in model PMA mass and number fluxes was observed in biologically productive waters, increasing following sunrise and decreasing to predawn levels overnight. Such variability was not seen in oligotrophic waters. During daytime, surfactant scavenging by aeration in the aerosol generator without replenishing the seawater in the reservoir reduced the model PMA production in productive waters to nighttime levels but had no influence on production from oligotrophic waters. Results suggest bubble plume interactions with sunlight-mediated biogenic surfactants in productive seawater significantly enhanced model PMA production. Key Points Surface ocean biogeochemistry mediates physics of marine aerosol production Diel cycles in biologically productive surface seawater mediate production Observations show chemical processes affecting mass and number production fluxes © 2014. American Geophysical Union. All Rights Reserved.