Introduction
Use this guide to replace the battery in your Samsung Galaxy Tab 3 10.1 tablet.
What you need
-
-
Insert an opening pick between the rear case and the plastic rim.
-
Slide the pick along the edge of the rear case until you release the plastic clips attaching the rear case to the display.
-
Continue to slide the pick around the edge of the rear case until all clips are released.
-
-
-
Use the flat end of a nlyon spudger to pry up the black plastic tabs securing the two ZIF connectors.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
75 other people completed this guide.
7 Comments
Great, Thanks for the help. It was very useful.
why are there white lines all over the screen after a new battery was installed
brilliant ! worked extremely well !
Thank you very much for the information. I have one question, though. The new battery works, but it takes a VERY long time to charge. More than a day, in fact. Any idea what could be causing that? Is it possible that one of the connections is not tight enough? If so, which connection might that be?
Thank you.
Very easy instructions. Thank you. My only snag was that the ten screws holding the battery were extremely reluctant to undo. wrecked the IFxit screw driver. Fortunately, I had another one. My tip for anyone doing this little job, is to use quit a lot of downward pressure on the screws. Turn them 1/4 turn anticlockwise and back again. Do this several times until they turn freely. You will then have an easy job. I will replace those screws with a tiny blob of 'Never Seize'.
