Introduction: $0 Phone Stand
Do you need a phone stand? But your too cheap to buy one with your own money!!! I got the solution for you.
Step 1: Scraping
The first step is to FIND some scrap 2x4, or 2x6. Something that is 1.5 inches thick.
Step 2: Initial Cut
Cut the wood in to smaller cubes on a scroll saw, table saw, miter saw, or a bandsaw. I uses a scroll saw for everything.
Step 3: 1st Sanding
Lightly sand the cubes with a belt, or disk sander.
Step 4: Main Cutting
On the saw if your choice cut out a shape similar to the one in the picture.
Step 5: 2nd Sanding
Sand the pice in till it's comfortable in your hands.
Step 6: Finishing
This step is optional. You can put some stain, wax, or lacquer on it to make it nicer. I used wax.