Azadirachta indica A. Juss (neem) extracts have been used in pharmaceutical applications as antitumor agents, due to their terpenes and phenolic compounds. To obtain extracts from neem leaves with potential antiproliferative effect, a sequential process of pressurized liquid extraction was carried out in a fixed bed extractor at 25 ºC and 100 bar, using hexane (SH), ethyl acetate (SEA) and then ethanol (SE) as solvents. An extraction using only ethanol (EE) was also conducted to compare the characteristics of the fractionated extracts. The results obtained by liquid chromatography-electrospray ionization mass spectrometry suggested the highest concentration of terpenes for SEA extract in comparison to SH, SE and EE extracts. Therefore, antiproliferative activity showed SEA extracts were the most efficient inhibitors to human tumor cells MCF-7, NCI-H460, HeLa, and HepG2 between all other extracts studied. However, hepatocellular normal cells were more resistant to SH, SEA, SE, and EE compared to malignant cells of breast, lung, hepatocellular, and cervical. Neem fractioned extracts obtained in the present study seem to be more selective for malignant cells compared to the normal cells.

Global demand for food shows an increasing trend, which implies that volumes of food waste also increase. These wastes contain bioactive compounds that are not properly utilized or valorized. It was reported that ginger waste contains phenolic compounds with high antioxidant activity. Thus, this study aimed to evaluate the effect of temperature, time, and particle size on the total phenolic content (TPC) and antioxidant activity (AA) of ginger (Zingiber officinale R.) waste aqueous extract using the Pressurized Liquid Extraction (PLE) method with water as the sole solvent. Box-Behnken design was used. The sample was 1.60 kg of dried ginger peel powder. Data analysis was performed with Minitab ® 19.1 (64-bit). TPC ranged from 10.42 to 14.1 mg GAE/g, and AA (DPPH method) ranged from 72.9 to 111.9 μmol TE/g. The model explained 81.07% of AA’s total variability. Positive correlation was found between TPC and AA (Pearson's ρ = 0.58, p < 0.05). Response optimization values were 126 °C and 38 min. Temperature was a significant factor (p < 0.05) influencing AA, while time and particle size were not significant. Higher temperatures, longer extraction times and smaller particle sizes increase TPC and AA of the ginger waste aqueous extract.

The nozzle is the key element of the water jet generator for energy conversion. In order to explore the influence of the nozzle diameter on the pressure characteristics of the supercharged pulsed water jet plenum chamber, a supercharged pulsed water jet pressure acquisition system was established, and the Equations of motion and theoretical pressurization ratio equations of the supercharged pulsed water jet generator were established. The pressurization chamber pressure acquisition experiments under different nozzle diameters were carried out. The research results indicate that there is a critical nozzle diameter. When the nozzle diameter is less than the critical diameter, the pressure in the boost chamber is equal to the product of the driving pressure and boost ratio. As the nozzle changes, there is no significant change in the peak pressure and frequency of the boost chamber; When the nozzle diameter is greater than the critical diameter, there is a non-linear relationship between the boost chamber pressure and the driving pressure. As the nozzle diameter gradually increases, the actual boost ratio gradually decreases, and the peak pressure of the boost chamber further decreases. The nozzle diameter can no longer provide a load for the establishment of fluid pressure in the boost chamber. The research results provide a research basis for further controlling the pressure characteristics of the boost pulse water jet.

Sweet cherry pomace is a by-product that can be a source of bioactive phenolic compounds. Usually, polyphenols have been extracted using conventional extraction methodologies. However, a significant fraction, called non-extractable polyphenols (NEPs), remains retained in the conventional extraction residues. Therefore, this work is aimed, for the first time, to investigate the release of NEPs from cherry pomace combining pressurized liquid extraction (PLE) and enzyme-assisted extraction (EAE) using Promod enzyme. A response surface methodology was employed to study the influence of temperature, time, and pH on the NEPs extraction. The response variables were the total phenolic content (TPC) measured by Folin-Ciocalteu method, total proanthocyanidin (PA) content evaluated by vanillin, DMAC, and butanol/HCl assays, and total antioxidant capacity determined by Trolox equivalent antioxidant capacity and inhibition of hydroxyl radical assays. The results indicated that PLE-EAE was more suitable and selective to obtain NEPs from sweet cherry pomace than PLE alone. In fact, the extracts obtained by PLE-EAE displayed higher TPC, PA content, and bioactivity than the extracts obtained by PLE under the same extraction conditions, and those obtained by conventional methods. Moreover, size-exclusion chromatography profiles showed that the combination of PLE and EAE enabled the recovery of NEPs with higher molecular weight than PLE without EAE treatment.

Considerable attention has recently been given to the contribution of greenhouse gas (GHG) emissions of the healthcare sector to climate change, which represents 4-6% of emissions worldwide. GHGs used in medical practice are regularly released into the atmosphere and contribute to elevation in global temperatures that produce detrimental effects on the environment and human health. Consequently, a comprehensive assessment of their global warming potential (GWP) characteristics and clinical uses, many of which have evaded scrutiny from policy makers due to their medical necessity, is needed. Of major interest are volatile anesthetics, analgesics, and inhalers, as well as fluorinated gases used as tamponades in retinal detachment surgery. In this review, we compare estimates of these gases’ GHG emissions in metric tons CO₂ equivalent (MTCO₂e) and their relative GWP. Notably, the anesthetics desflurane and nitrous oxide contribute the most emissions out of the major medical GHGs, equivalent to driving 12 million gasoline-powered cars annually in the US. Retinal tamponade gases have markedly high GWP up to 23,500 times compared to CO₂ and long atmospheric lifetimes up to 10,000 years, thus bearing the potential to contribute to climate change long-term. This review provides the basis for discussions on examining the environmental impacts of medical gases with high GWP, determining whether alternatives may be available, and reducing emissions while maintaining or even improving patient care.

In a Water-Cooled Lithium-Lead (WCLL) Breeding Blanket (BB), the heat generated by the plasma thermal radiation and nuclear reactions is removed mainly by two components; namely, the First Wall (FW) and the Breeding Zone (BZ). The FW faces the neutrons and charged particles fluxes generated by the fusion reactions and the thermal radiation coming from the plasma. The present work takes into account the FW cooling system inspired by the WCLL BB 2018 design of DEMO 2017 baseline. Unlike the baseline where a Pressurized-Water Reactor (PWR) setup is used for the coolant, various setup between the Boiling Water Reactor (BWR) and the High-Pressure (HP) BWR are studied in the present work operating in the Two-Phase Flow (TPF) regime. The 3D model of the FW in the WCLL BB 2018 design is simplified into a 1D model and a steady state analysis is carried out to optimize the mass flow rate of the water and the number of parallel channels at the BB cells at different poloidal locations of the reactor, which helps not only in reducing the used coolant but also in improving the Tritium Breeding Ratio (TBR). The present work takes into account forced convection in the liquid only region, the subcooled boiling region, and the saturated boiling region using suitable empirical or semi-empirical models from the literature. The results are validated against the existing results in the literature. In the end, related conclusions are made regarding the pros and cons of the studied operating conditions.