Assessing estimates

Human health risk assessment estimates the likelihood of health problems occurring if no cleanup action were ttikcn at the site. To cstiimite the baseline risk at a site, the following four-step process should be taken to detennine Uie possible human risk which will then detennine what sort of corrective action should be employed ... [Pg.296]

If linear (dose) models without thresholds are to be used for carcinogen (or other) risk assessment, estimation of exposure at specified levels becomes irrelevant to risk assessment or, at least, its use is nonintuitive. For example, a carcinogen risk analysis may be based on a linear, nonthreshold health effects model. The total health risk would thus be proportional to the long-term exposure summed for all affected people for the identified period, and exposure of many people at low concentrations would be equivalent to exposure of a few to high concentrations. The atmospheric dispersion that reduces concentrations would also lead to exposure of more people therefore, increments... [Pg.71]

Risk assessment and epidemiology could be successfully combined to analyze environmental health risks. Exposure assessments estimate concentrations of toxic chemicals in the environment that could be transferred to humans by ingestion, inhalation, or dermal absorption. In the future, there will be a greater need for agreement on how best to simultaneously assess societal risks involved with damage to both ecosystems and the human population (Ruttenber, 1993). [Pg.253]

Wein and Liu (2005) modeled a bioterror attack using BoNTs on the nation s milk supply. Modeling of toxin for dispersal in a liquid medium has been previously computed in a terrorist scenario (Dembek, 2005) involving a water fountain and contamination at a recreational center (CDC, 1999). Wein and Liu s assessment estimates the amount of toxin required, critically evaluates entry points into the milk supply industry, and details deficiencies in our current detection capabilities required to thwart such an attack (Wein and Liu, 2005). [Pg.426]

For MTBE, ERA has not formally established health effects and reference dose. A preliminary estimate of the threshold reference concentration was developed for this risk assessment. Estimated concentrations for the MEI location were 10-15% of the reference concentration. No further evaluation was done for MTBE. [Pg.352]

Burmaster DE and von Stackelberg K (1991) Using Monte Carlo simulations in public health risk assessment Estimating and presenting full distributions of risk. Journal of Exposure Analysis and Environmental Epidemiology 1 491-512. [Pg.1740]

The largest emissions are thought to be from the use and disposal of CPs in metal working fluids. The US EPA estimated these at 10% for SCCPs [2] while the EU assessment estimated releases at 18.5% from oil-based fluids and 31.6% from water-based (emulsifiable) fluids [3]. The other significant source of release is from losses during the service life of products containing CP polymers (PVC, other plastics, paints, sealants, etc.) [3, 4]. These releases, estimated to be overall <1% of the CPs incorporated into the product matrix, are anticipated to be mainly to urban/industrial soil and to wastewater (Table 1). [Pg.110]

Identification of outcome and estimation of the probabilities of these outcomes. Source-release assessment Estimates the amounts, frequencies, and locations of the introduction, release, or escape of risk agents (eg, toxic chemicals) frcnn specific sources (eg, manufaaunng plants) into occupational, residential, or outdoor environments. ... [Pg.17]

Exposure assessment estimates the number of exposed persons together with the magnitude, duration and frequency of exposure. A direct possibility to measure the human exposure to toxic substances via ambient air, for example, is the utilization of personal monitors. [Pg.362]

This experimental strategy provides a multitiered approach with Phases I and II the prime tiers. Use of this multitiered approach provides data sufficient for risk assessment estimates, yet is done in a time, materials and cost effective manner. [Pg.45]

By considering exposure as well as hazard, the process of risk assessment estimates the potential for the inherent hazards of a material actually to be realised during its life cycle. It should be carried out if a proposed solvent/preparation is subject to specific water pollution controls or has been classified as dangerous to the environment. The results will lend support to discussions with pollution authorities. [Pg.123]

Operating conditions may vary from time to time. Economic assessment estimated based on average values must be revised to take variations into account so that more... [Pg.447]

Estimation of losses in urban areas from future earthquakes is essential for disaster preparedness and decision making at the local, regional and national levels of government. The process of loss estimation due to earthquakes involves different analyses, such as seismic hazard assessment, estimation of earthquake characteristics on the ground surface, vulnerability and fragility analyses of structures and human casualties. Various numerical and empirical methods have been developed over the past years to perform each of these analyses yet, few attempts have been made to combine the whole process into a single computer code. [Pg.377]

Perfection implies repetition of assessment, estimation, calculation, evalnation, analysis and computation (Fenton and Hill, 1993) ... [Pg.16]

Data assessments and entry preparations The original journal articles were reviewed to determine the quality of the data. For papers containing data under current purview of the DIPPR 882 project, all relevant data in each paper, including mixtures that were not under current purview, were assessed. Estimates of the measurement precision and the accuracy of the values for each variable, for example (7 p, x, viscosity), associated with the data were expressed as equations. In exceptional cases, imprecisions for individual data points were recorded with the body of the reported data. Assessments of the purity of the substances contained in the mixtures were recorded using the format developed for the TRC SOURCE Database. The purity assessments were used to place subjective confidence in the data. Only in the rare instances where the nature and concentration of impurities were given could quantitative use be made of purity information. In many instances only a small... [Pg.462]

Risk assessment of hazardous substances transportation may be realized by means of various methods based on qualitative assessment (estimating merely the consequences of accidents) as well as complicated quantitative methods (which, apart from estimating consequences of accidents, determine probability of accident occurrence). [Pg.1672]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...