Potentials vector

Maxwell s equation are the basis for the calculation of electromagnetic fields. An exact solution of these equations can be given only in special cases, so that numerical approximations are used. If the problem is two-dimensional, a considerable reduction of the computation expenditure can be obtained by the introduction of the magnetic vector potential A =VxB. With the assumption that all field variables are sinusoidal, the time dependence... [Pg.312]

For the field calculation it more convenient to use a tx(B) curve than the normal ix(H) curve because the calculated vector potential A is derived from the flux density B. This ii(B) curve however can be calculated easily from the measured values. [Pg.314]

B. Vector-Potential Theory The Molecular Aharonov-Bohm Effect... [Pg.25]

The term a, therefore plays the role of a vector potential in electromagnetic theory, with a particularly close connection with the Aharonov-Bohra effect, associated with adiabatic motion of a charged quantal system around a magnetic... [Pg.26]

We now consider the connection between the preceding equations and the theory of Aharonov et al. [18] [see Eqs. (51)-(60)]. The tempting similarity between the structures of Eqs. (56) and (90), hides a fundamental difference in the roles of the vector operator A in Eq. (56) and the vector potential a in Eq. (90). The fomrer is defined, in the adiabatic partitioning scheme, as a stiictly off-diagonal operator, with elements (m A n) = (m P n), thereby ensuring that (P — A) is diagonal. By contiast, the Mead-Truhlar vector potential a arises from the influence of nonzero diagonal elements, (n P /i) on the nuclear equation for v), an aspect of the problem not addressed by Arahonov et al. [18]. Suppose, however, that Eq. (56) was contracted between (n and n) v) in order to handle the adiabatic nuclear dynamics within the Aharonov scheme. The result becomes... [Pg.27]

Some final comments on the relevance of non-adiabatic coupling matrix elements to the nature of the vector potential a are in order. The above analysis of the implications of the Aharonov coupling scheme for the single-surface nuclear dynamics shows that the off-diagonal operator A provides nonzero contiibutions only via the term (n A n). There are therefore no necessary contributions to a from the non-adiabatic coupling. However, as discussed earlier, in Section IV [see Eqs. (34)-(36)] in the context of the x e Jahn-Teller model, the phase choice t / = —4>/2 coupled with the identity... [Pg.28]

Appendix A The Jahn-Teller Model and the Herzberg-Longuet-Higgins Phase Appendix B The Bom-Oppenheimer Treatment Appendix C Formulation of the Vector Potential References... [Pg.40]

Finally, in brief, we demonstrate the influence of the upper adiabatic electronic state(s) on the ground state due to the presence of a Cl between two or more than two adiabatic potential energy surfaces. Considering the HLH phase, we present the extended BO equations for a quasi-JT model and for an A -1- B2 type reactive system, that is, the geometric phase (GP) effect has been inhoduced either by including a vector potential in the system Hamiltonian or... [Pg.43]

As mentioned in the introduction, the simplest way of approximately accounting for the geomehic or topological effects of a conical intersection incorporates a phase factor in the nuclear wave function. In this section, we shall consider some specific situations where this approach is used and furthermore give the vector potential that can be derived from the phase factor. [Pg.44]

The non-adiabatic effect on the ground adiabatic state dynamics can as mentioned in the introduction be incorporated either by including a vector potential... [Pg.44]

The effective nuclear kinetic energy operator due to the vector potential is formulated by multiplying the adiabatic eigenfunction of the system, t t(/ , r) with the HLH phase exp(i/2ai ctan(r/R)), and operating with T R,r), as defined in Eq. fl), on the product function and after little algebraic simplification, one can obtain the following effective kinetic energy operator. [Pg.45]

Single surface calculations with a vector potential in the adiabatic representation and two surface calculations in the diabatic representation with or without shifting the conical intersection from the origin are performed using Cartesian coordinates. As in the asymptotic region the two coordinates of the model represent a translational and a vibrational mode, respectively, the initial wave function for the ground state can be represented as. [Pg.47]

Single-surface calculation with vector potential,... [Pg.52]

In the presence of a phase factor, the momentum operator (P), which is expressed in hyperspherical coordinates, should be replaced [53,54] by (P — h. /r ) where VB creates the vector potential in order to define the effective Hamiltonian (see Appendix C). It is important to note that the angle entering the vector potential is shictly only identical to the hyperangle <]> for an A3 system. [Pg.53]

Thus, the total effective Hamiltonian (H) in the presence of a vector potential is now defined and it is for an type reactive system (9q = 0) given by... [Pg.56]

The total effective Hamiltonian H, in the presence of a vector potential for an A + B2 system is defined in Section II.B and the coupled first-order Hamilton equations of motion for all the coordinates are derived from the new effective Hamiltonian by the usual prescription [74], that is. [Pg.56]

The relative shift of the peak position of the rotational distiibution in the presence of a vector potential thus confirms the effect of the geometric phase for the D + H2 system displaying conical intersections. The most important aspect of our calculation is that we can also see this effect by using classical mechanics and, with respect to the quantum mechanical calculation, the computer time is almost negligible in our calculation. This observation is important for heavier systems, where the quantum calculations ai e even more troublesome and where the use of classical mechanics is also more justified. [Pg.58]

Figure 2. Quantum classical cross-sections for the reaction D-I-Ha (r — l,j — 1) DH (v — l,/)-l-H at 1.8-eV total energy as a function of /. The solid line indicates results obtained without including the geometric phase effect. Boxes show the results with geometric phase effect included using either a complex phase factor (dashed) or a vector potential (dotted).

At this stage, we would like to mention that the model, without the vector potential, is constructed in such a way that it obeys certain selection rules, namely, only the even —> even and the odd —> odd transitions are allowed. Thus any deviation in the results from these selection rules will be interpreted as a symmetry change due to non-adiabatic effects from upper electronic states. [Pg.71]

As demonstrated in [53] it is convenient to incorporate the geometrical phase effect by adding the vector potential in hyperspherical coordinates. Thus we found that the vector potential gave three terms, the first of which was zero, the second is just a potential term... [Pg.76]

See also in sourсe #XX -- [ Pg.294 ]

See also in sourсe #XX -- [ Pg.28 ]

See also in sourсe #XX -- [ Pg.294 ]

See also in sourсe #XX -- [ Pg.106 , Pg.123 ]

See also in sourсe #XX -- [ Pg.215 , Pg.282 ]

See also in sourсe #XX -- [ Pg.114 ]

See also in sourсe #XX -- [ Pg.2 ]

See also in sourсe #XX -- [ Pg.61 ]

See also in sourсe #XX -- [ Pg.69 , Pg.75 ]

See also in sourсe #XX -- [ Pg.30 , Pg.65 ]

See also in sourсe #XX -- [ Pg.22 ]

See also in sourсe #XX -- [ Pg.117 ]

See also in sourсe #XX -- [ Pg.22 ]

See also in sourсe #XX -- [ Pg.103 ]

See also in sourсe #XX -- [ Pg.35 ]

See also in sourсe #XX -- [ Pg.183 ]

See also in sourсe #XX -- [ Pg.228 ]

See also in sourсe #XX -- [ Pg.69 , Pg.75 ]

See also in sourсe #XX -- [ Pg.79 , Pg.81 , Pg.82 , Pg.85 , Pg.94 , Pg.97 , Pg.98 , Pg.100 , Pg.112 , Pg.151 ]

See also in sourсe #XX -- [ Pg.215 ]

See also in sourсe #XX -- [ Pg.17 , Pg.152 , Pg.153 , Pg.154 , Pg.157 ]

See also in sourсe #XX -- [ Pg.80 , Pg.87 , Pg.88 , Pg.146 ]

See also in sourсe #XX -- [ Pg.523 ]

See also in sourсe #XX -- [ Pg.42 , Pg.181 ]

See also in sourсe #XX -- [ Pg.2 ]

See also in sourсe #XX -- [ Pg.36 , Pg.241 ]

See also in sourсe #XX -- [ Pg.11 ]

See also in sourсe #XX -- [ Pg.12 ]

See also in sourсe #XX -- [ Pg.43 ]

See also in sourсe #XX -- [ Pg.20 ]

See also in sourсe #XX -- [ Pg.22 ]

See also in sourсe #XX -- [ Pg.12 , Pg.16 , Pg.23 , Pg.25 , Pg.93 , Pg.96 , Pg.105 ]

See also in sourсe #XX -- [ Pg.108 ]

See also in sourсe #XX -- [ Pg.117 ]

See also in sourсe #XX -- [ Pg.658 ]

See also in sourсe #XX -- [ Pg.266 ]

See also in sourсe #XX -- [ Pg.97 ]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...