Radio's Sleeper Build

I have been wanting to do a sleeper build for a while, but when I initially looked at the cases I had to choose from, I realized that I'd have to put in some elbow grease and I got deterred. 2 years later and I decided to fully commit on the idea! The most annoying part about the build is definitely the cooling; I cannot run the PC with the side panel on if I'm doing any amount of gaming as the air intake and outake between the two fans are just not good enough for it to cool the system.

Had to dremel out the back of the case (similar to https://i.imgur.com/NN9qdhg.jpeg), preparing the case was a bit of a mess but it worked out in the end!
I do have an unorthodox cooling setup as the back fan mount was a weird size. However, the stock fan on the stock cooler of the 5600X fit perfectly! I unfortunately broke the plastic that was keeping it connected to the AMD shroud that surrounds it, so I can no longer claim warranty on it at Micro Center. I had to drill holes in the metal portion in the front of the case (behind the plastic cover that goes over front I/O). I also had to drill holes in the Gateway piece that attaches to that cover so that air flows through it slightly better.

I also had to buy a 3.5" to 5.5" adapter to mount my HDD inside the PC. I tried 3D printing out a mount but it did not screw into the piece so I bought a $5 adapter from Amazon. It gets the job done, but I had to use the black front piece that covers it as opposed to the original PC case piece, as the original juts out enough to where it does not fit.