Brushless
Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
SPI Isolator Click is a compact add-on board with a digital isolator optimized for a serial peripheral interface. This board features the ADuM4154, a 5kV digital isolator optimized for a serial peripheral interface (SPI) from Analog Devices. Based on the iCoupler® chip scale transformer technology, the low propagation delay and jitter in the SCLK, SI, SO, and SSS SPI bus signals support SPI clock rates of up to 17MHz.It also provides a slave select multiplexing system that allows up to four slave devices to be serviced from one isolator. When a target slave is selected, the slave select signal propagates to the desired output with low propagation delay, allowing tight timing control. This Click board™ is suitable for general SPI-bus isolation, industrial automation systems, sensor isolation, and many other applications.
SPI Isolator Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-2583$35.00
PWM 2 click offers 48 independently controlled PWM channels, available over the onboard headers, perfectly suited for driving LEDs. Each channel has a 12-bit PWM register associated to it, with the addition of the 6-bit correction register, also known as the dot correction register. PWM 2 is able to detect both synchronization errors and open LED errors, signaling the error via the dedicated pin and the status frame. The Click board™ fully supports cascading, exposing all the necessary pins on the onboard headers, so it can support a large array of LED elements.
MIKROE-3148$32.00
MPU 9DOF Click is a compact add-on board that contains a 9-axis inertial measurement unit. This board features InvenSense’s MPU-9250, a multi-chip module (MCM) consisting of a 3-axis MEMS gyroscope, accelerometer, and magnetometer with three 16-bit ADCs and signal conditioning unit. For precision tracking of both fast and slow motions, the MPU-9250 features a user-programmable full-scale gyroscope range of ±250, ±500, ±1000, and ±2000dps, accelerometer range of ±2g, ±4g, ±8g, and ±16g, and a magnetometer range of ±4800μT, alongside a configurable host interface that supports both SPI and I2C serial communication. This Click board™ is suitable for consumer electronics equipment such as angle measurements, motion detection, gesture position, or as a pedometer.
MPU 9DOF Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-1719$45.00
Load Cell 6 Click is a compact add-on board representing a weigh scale solution. This board features the MAX11270, a high-performance 24-bit delta-sigma ADC that achieves excellent 130dB SNR while dissipating an ultra-low 10mW from Analog Devices. This SPI-configurable ADC sample rates up to 64ksps allow precision DC and AC measurements, with integral non-linearity guaranteed to 4ppm maximum. The MAX11270 offers a 6.5nV/√Hz noise programmable gain amplifier with gain settings between 1x to 128x. Optional buffers are also included to isolate the signal inputs from the switched capacitor sampling network, which allows the MAX11270 to be used with high-impedance sources without compromising the available dynamic range. This Click board™ is suitable for weight scale applications in various use cases.
Load Cell 6 Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-4940$62.00
