1. Oil Pump; Low Oil Pressure Warning Light Switch; Installation - Triumph TIGER Service Manual
Hide thumbs
Also See for TIGER:
- Service manual (377 pages) ,
- Handbook (118 pages) ,
- Operation manual (114 pages)
Table of Contents
Advertisement
3. Fit the oil pump to the crankcase, ensure the water
pump drive peg locates into the drive on the water
pump shaft. Tighten the bolts to 13.7 Nm.
-
'r
'
:::-
0
,
'
Insertion
Pump
4. As an assembly, slide the upper drive sprocket
bearing, upper
sprocket, drive chain and pump
drive
sprocket onto the input shaft and oil
,-_== \/_
O
1
2
o
ka
drive chain
1. Oil pump
2. Pump drive sprocket fixing
drive
3. Pump
sprocket
4. Tool T3880371
5.
Locate the pump drive sprocket onto the pump
ensuring that the drive engages correctly.
6.
Refit tool T3880371 to the upper drive sprocket and
tighten a new oil pump drive sprocket centre bolt to
15 Nm. Remove the tool.
7.
Assemble the clutch (see page 4-9).
8.
Reconnect the battery, positive (red lead) first.
9.
Refill the engine with oil (see page 8-7).
TRJUMPM
Low Oil Pressure Warning Light
Switch
The low oil pressure warning light switch is located at the
//
lower end of the camshaft oil feed pipe.
pump.
0
1.
2.
cc
3.
D
p
3
4.
C 0
Installation
4
1.
2.
3.
4.
Service Manual - Tiger
Remove the seat (see page 16-9).
Disconnect the battery negative (black)
covering boot
and disconnect the electrical
Lift the
connection to the switch.
and
collect the copper washers.
Remove the switch
Using new copper washers on both sides of the oil
pipe union, fit
switch and tighten to 13 Nm.
the
Refit the electrical connection.
Refit the covering boot.
Reconnect the battery, positive (red) lead first.
Lubrication
lead
first.
8.11
- Quick Links:
- Electrical Wires
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the TIGER and is the answer not in the manual?
Questions and answers