Model: M5STACK-A066
Brand: M5Stack
This is an M5Stack FACES fingerprint module.
Specifications:
Interface Serial UART2 (16/17)
FPC1020A algorithm chip
Sensor surface area: 192*192 Pixels
Pixel resolution: 256 grayscale levels (8 Bit)
Operating temperature: - 40 to + 8..
€18.00
Ex Tax:€14.88
Model: M5STACK-U074
Brand: M5Stack
The M5Stack Finger Print Hat is an add-on for the M5StickC* with a built-in FPC1020SC fingerprint sensor.
Specifications:
Built-in FPC1020SC sensor
Designed for use with M5StickC*
UART communication
UART settings:
Baudrate:..
€24.00
Ex Tax:€19.83
Model: M5STACK-U008
Brand: M5Stack
The M5Stack Finger Print Unit is a fingerprint sensor module with built-in FPC1020A.
Specifications:
Built-in FPC1020A sensor
2x LEGO® holes for mounting
Grove interface
UART communication
UART settings:
Baudrate: 19200bp..
€22.00
Ex Tax:€18.18
Model: MPR121
The MPR121 touch module can read up to 12 channels of touch. 8 channels can also be used to control LEDs.
The module works via I2C and operates at a voltage between 2.5 and 3.6VDC.
Do you want to get started with this module? Look here: Sensing ..
€4.00
Ex Tax:€3.31
Model: TOUCH1CHBLUE
A small touch square that glows blue when you press it with your finger and can transmit a signal (touch works capacitively).
This module remains on after contact and only turns off when it is touched (can therefore be used as on/off switch).
The m..
€3.00
Ex Tax:€2.48
Model: TOUCH1CHGREEN
A small touch surface that glows green when you press it and can transmit a signal (touch works capacitively).
This module stays on after contact and only goes out when it is touched (can therefore be used as on/off switch).
The module operates at ..
€3.00
Ex Tax:€2.48
Model: TOUCH1CHRED
A small touch area that glows red when you press it with your finger and can pass a signal (touch works capacitively).
This module remains on after contact and only goes out when it is touched (can therefore be used as on/off switch).
The module op..
€3.00
Ex Tax:€2.48
Model: TOUCH1CHYELLOW
A small touch square that glows yellow when you press it with your finger and can pass a signal (touch works capacitively).
This module remains on after contact and only goes out when it is touched (can therefore be used as on/off switch).
The modu..
€3.00
Ex Tax:€2.48
Model: TTP223B
A 1 channel touch module. Specifications:
Voltage: 2.0 - 5.5VDC (on the Vcc and GND)
1 LED to show the status of the touch.
1 put pin for the touch status (SIG pin)
Dimensions: 24 x 24mm..
€2.50
Ex Tax:€2.07
Model: TTP223BRED
A 1 channel touch module. Specifications:
Voltage: 2.0 - 5.5VDC (on the Vcc and GND)
1 LED to show the status of the touch.
1 output pin for the touch status (I/O pin)
Option for high/low output and function as Reset butto..
€1.00
Ex Tax:€0.83
Model: TTP224
A 4 channel touch module.
Specifications:
Voltage: 2.4 - 5.5VDC (on the Vcc and GND)
4 LEDs to show the status of the touch.
4 output pins for the touch status
Dimensions: 35 x 29 mm
Note: The module may be delivered with separate..
€3.00
Ex Tax:€2.48
Model: TTP229
A 16 channel touch module. Specifications:
Voltage: 2.4 - 5.5VDC (on the Vcc and GND)
16 output pins for touch status
Possible to read the pins serially (SCL and SDO) Note: This is not I2C!
Dimensions: 49 x 65mm
For more informat..
€4.00
Ex Tax:€3.31
Model: TOUCHSENSORMOD
This is a simple touch sensor, you can adjust the sensitivity with the potentiometer...
€2.50
Ex Tax:€2.07
Model: WS-13694
Brand: Waveshare
With this module a fingerprint can be read with a PC, Raspberry Pi, Arduino or other microcontroller. The fingerprint reader is connected via UART or USB.
Specifications:
Supply voltage: 3.3-5V DC
Signal voltage: 3.3-5V
Communication:
..
€47.00
Ex Tax:€38.84
Model: WS-20903
Brand: Waveshare
With this module a fingerprint can be read with a Raspberry Pi, Arduino or other microcontroller. The fingerprint reader is connected via UART...
€19.50
Ex Tax:€16.12
Showing 1 to 16 of 16 (1 Pages)